The main purpose of this paper was to reveal the effect of aluminum (Al)-based coagulants on enhanced coagulation for the removal of algae and the synergistic optimization mechanism among different Al species. The formation, breakage, and regrowth processes of algal coagulation flocs formed by a series of monomeric Al-based coagulants (Al₂(SO₄)₃, Al₁₃, and Al₃₀), Al₁₃/Al₃₀ composite coagulant and poly(diallyldimethylammonium chloride)/Al₁₃ (PDADMAC/Al₁₃) composite coagulant were studied. Results indicated that Al₁₃ mainly employed a charge neutralization mechanism, which was conducive to the destabilization of algae and the regeneration of flocs, while Al₃₀ mainly employed a sweep flocculation mechanism, which was conducive to the formation of algae and the strength of flocs. Meanwhile, the charge neutralization was the main mechanism during the algae coagulation process because it could effectively remove the soluble microbial products (SMP) component in the extracellular organic matter (EOM). Therefore, Al₁₃ could achieve a higher coagulation performance than other monomeric Al-based coagulants. The Al₁₃/Al₃₀ composite coagulant could make up for the deficiency of the sweep flocculation mechanism in Al₁₃ and charge neutralization mechanism in Al₃₀, and achieve the best synergistic optimization performance at Al₁₃:Al₃₀-7:3. Additionally, PDADMAC, as a polymer, could further enhance the charge neutralization ability of Al₁₃ at low dosages and the sweep flocculation ability of Al₁₃ at high dosages, respectively. However, an excessive dosage would lead to charge reversal and thus reduce the coagulation effect. Therefore, controlling the dosage was key when using Al-composite coagulants. The findings of our research could offer a certain theoretical foundation for the development of inorganic polymer flocculants.

This study aimed to explore the response of archaeal communities and antibiotic-resistance genes (ARGs) to ciprofloxacin (CIP, 0.05–40 mg/L) and copper (Cu, 3 mg/L) combined pollution during stress- and post-effect periods in an activated sludge system. With the increase in the CIP concentration, the diversity of archaea decreased, but the richness increased under the stress of 10 mg/L CIP. Under stress and post effects, the change in unknown archaeal community structure was more significant than that of the known archaea. The relative abundance of unknown archaea was significantly reduced with the increase in CIP concentration. Meanwhile, there were certain archaea that belonged to abundant and rare taxa with different resistance and recovery characteristics. Among them, Methanosaeta (49.15–83.66%), Methanoculleus (0.11–0.45%), and Nitrososphaera (0.03–0.36%) were the typical resistant archaea to combined pollution. And the resistance of the abundant taxa to combined pollution was significantly higher than that of the rare taxa. Symbiotic and competitive relationships were observed between the known and the unknown archaea. The interactions of abundant known taxa were mainly symbiotic relationships. While the rare unknown taxa were mainly competitive relationships in the post-effect period. Rare archaea showed an important ecological niche under the stress-effect. Some archaea displayed positive correlation with ARGs and played important roles as potential hosts of ARGs during stress- and post-periods. Methanospirillum, Methanosphaerula, Nitrososphaera and some rare unknown archaea also significantly co-occurred with a large number of ARGs. Overall, this study points out the importance of interactions among known and unknown archaeal communities and ARGs in a wastewater treatment system under the stress of antibiotics and heavy metal combined pollution.

The acceleration of urbanization has disrupted natural water cycles, resulting in increased impervious urban surfaces and non-point source pollution from stormwater runoff. Addressing urban stormwater recharge has become crucial. This study introduces a novel silica sand-based permeable filtration material, investigating its surface characteristics, pore structure, permeability, and pollutant interception capabilities. The results demonstrate that hydrophilic binder coating modification of the permeable surface sand aggregate, combined with hydrophilic inorganic additives, having a porous structure with an average pore size of less than 50 μm and a porosity between 15% and 35%, significantly enhances surface hydrophilicity, achieving a permeation rate of up to 6.8 mL/(min·cm²). Moreover, it shows exceptional filtration and anti-clogging properties, achieving over 98% suspended solids interception and strong resistance to fouling. Dynamic biofilm formation experiments using simulated rain and domestic wastewater explore biofilm morphology and function on silica sand filtration well surfaces. Mature biofilms sustain COD removal efficiency exceeding 70%, with levels consistently below 50 mg/L, NH₄⁺ decreasing to 2 mg N/L, and total nitrogen maintained below 10 mg N/L. The system features anoxic, anoxic, and aerobic zones, fostering synergistic organic matter and nitrogen removal by diverse microorganisms, enhancing pollutant mitigation. Silica sand-based permeable filtration material effectively mitigates urban stormwater runoff pollutants—suspended solids, organic matter, and nitrogen—offering an innovative solution for sponge city development and rainwater resource management.

Due to widespread industrial applications and increased discharges, concentrations of polyfluoroalkyl substances (PFAS) in potential drinking water sources have risen significantly, putting more people at risk of PFAS exposure. This study aimed to systematically clarify the occurrence characteristics (concentrations, detection frequencies, and temporal trends) of PFAS in global potential drinking water sources over the past decade, assess their oral exposure risks, and identify key PFAS species with high detection frequencies, high contamination levels, or high toxicity risks, thereby providing scientific support for the development of targeted control technologies and management strategies. This study systematically searched and reviewed the relevant literature published between 2014 and 2024 on PFAS levels in global potential drinking water sources, extracting data on PFAS concentrations, detection information, and sampling characteristics. Using the U.S. Environmental Protection Agency (EPA) Reference Dose (RfD) for oral exposure as the Acceptable Daily Intake (ADI), we evaluated the exposure risks of eight specific PFAS via the Risk Quotient for Specific Contaminants (RQ_RSC) model and analyzed the annual detection trends of the top thirty PFAS with the highest detection frequencies. Regarding total PFAS contamination, China, Brazil, Germany, South Africa, and the Danube River Basin exhibited particularly high levels, with China being the most severely contaminated. Risk assessment indicated that 45.6% of global potential drinking water sources were at high risk (RQ_RSC > 1), while 48.4% were at low risk (RQ_RSC < 0.2). Among the evaluated PFAS, PFOA, PFOS, PFDA, and GenX were associated with higher toxicity exposure risks. For the identified key concern PFAS, it is necessary to simplify detection techniques, promote targeted large-scale safe treatment technologies, and explore intelligent monitoring tools to reduce regulatory lag, thereby effectively monitoring, preventing, and controlling PFAS contamination.

Emerging pollutants such as microplastics in water environments readily accumulate microorganisms on their surfaces, forming biofilms and concentrating antibiotic-resistant bacteria (ARB) and antibiotic resistance genes (ARGs). Consequently, microplastic biofilms have attracted the attention of researchers. Horizontal gene transfer (HGT) of ARGs is one of the primary ways that bacteria acquire antibiotic resistance. Most studies focus on the effects of nanomaterials on suspended bacteria, but microplastic biofilms as hotspots for horizontal gene transfer also warrant significant investigation. This study primarily explored and compared the effects of nano-titanium dioxide on the conjugation transfer frequency of ARGs in suspended bacteria and microplastic biofilms. Nano-titanium dioxide could promote ARG conjugation in both suspended bacteria and microplastic biofilms, with a greater effect on the former. The mechanism involved nano-titanium dioxide promoting the production of reactive oxygen species (ROS) in suspended and biofilm bacteria, increasing the synthesis of outer membrane proteins, enhancing the cell membrane permeability, and elevating the expression levels of conjugation-related genes, thereby facilitating the conjugation transfer of ARGs. Biofilm bacteria, being heavily encased and protected by extracellular polymeric substances (EPS), exhibit greater resistance to external environmental pressure, resulting in the weaker impact of nano-titanium dioxide on biofilm bacteria compared to suspended bacteria. This study reveals the risk of ARG conjugation transfer within microplastic biofilms induced by nanomaterials, providing valuable insights into the risks of microplastic and antibiotic resistance dissemination in water environments.

The widespread use of antibiotics has led to the persistence of antibiotic-resistant bacteria (ARB) and antibiotic resistance genes (ARGs) in drinking water systems, posing potential public health risks at the point of use. In this study, a residential secondary water supply system (SWSS) in eastern China was investigated over one year to characterize microbial communities, ARB and ARG occurrence, and their associations with water quality in bulk water and biofilms. Culture-based methods, flow cytometry, quantitative PCR, and high-throughput 16S rRNA and ITS sequencing were applied. Although conventional treatment removed 94.8% of total bacteria, significant microbial regrowth occurred during secondary distribution, with the highest heterotrophic plate counts observed in rooftop storage tanks (up to 4718 CFU/mL). ARG concentrations increased along the distribution line, and the class 1 integron intI1 was enriched in downstream locations, indicating enhanced horizontal gene transfer potential. Sulfonamide resistance genes dominated the resistome, accounting for more than 60% of total ARG abundance in water samples. Seasonally, ARG levels were higher in autumn and winter, coinciding with elevated disinfectant residuals and lower temperatures. Chlorine was negatively associated with total bacterial abundance, while positive correlations were observed with the relative abundance of several ARGs when normalized to bacterial biomass, suggesting selective pressure under oxidative stress. Turbidity and bacterial abundance were positively correlated with ARB, particularly sulfonamide-resistant bacteria. Biofilms exhibited more stable microbial communities and provided microhabitats that facilitated microbial persistence. Notably, fungal abundance showed strong positive correlations with multiple ARGs, implying that microbial interactions may indirectly contribute to ARG persistence in SWSSs. These findings highlight the role of secondary distribution conditions, disinfectant pressure, and microbial interactions in shaping resistance risks in residential water supply systems, and provide insights for improving microbial risk management at the point of consumption.