The physical constraints of ever-shrinking CMOS transistors are rapidly approaching atomistic and quantum mechanical limits. Therefore, research is now directed towards the development of nanoscale devices that could work efficiently in the sub-10 nm regime. This coupled with the fact that recent design trend for analog signal processing applications is moving towards current-mode circuits which offer lower voltage swings, higher bandwidth, and better signal linearity is the motivation for this work. A digitally controlled DVCC has been realized using CNFETs. This work exploited the CNFET’s parameters like chirality, pitch, and numbers of CNTs to perform the digital control operation. The circuit has minimum number of transistors and can control the output current digitally. A similar CMOS circuit with 32 nm CMOS parameters was also simulated and compared. The result shows that CMOS-based circuit requires 418.6 μW while CNFET-based circuit consumes 352.1 μW only. Further, the proposed circuit is used to realize a CNFET-based instrumentation amplifier with digitally programmable gain. The amplifier has a CMRR of 100 dB and ICMR equal to 0.806 V. The 3 dB bandwidth of the amplifier is 11.78 GHz which is suitable for the applications like navigation, radar instrumentation, and high-frequency signal amplification and conditioning.
In this work, a single active element (Extra-X Current Controlled Conveyor) with grounded capacitor is used to design a reconfigurable first-order universal filter (CFUF). By simply swapping the digital control words (k1k2), the suggested circuit may implement all of the common filter responses, including high-pass, low-pass, and all-pass. An EX-CCCII serves as the active element in the filter setup, which is based on a novel topology, which provides several advantages, such as reduced complexity, low power consumption, and improved performance. The following advantages of the proposed circuit: high input impedance for voltage input signals, electronically controllable pole frequency that varies with bias current, and a single grounded capacitor that can be integrated into an IC. At a power supply level of ±0.5 V, the proposed circuit is modeled using specifications for 0.18-micrometer CMOS technology. PSPICE simulation tool is used to demonstrate the filter’s performance.
In this work, design and simulation of an active biquad filter based on carbon nanotube field effect transistor is presented. The filter uses current conveyor as an active element that can work up to tens of GHz range of frequencies and could be used for high frequency applications. Moreover, filtering operations in the entire Bluetooth range (2.40 - 2.48 GHz) are demonstrated via tuning of a resistor. HSPICE simulation with 32 nm CNFET model, have been carried out to test the integrity of the design.
2 September 2021 in International Journal of Information Technology
In this paper, the study is supported by design, FEA simulation, and practical RF measurements on fabricated single-port-cavity-based acoustic resonator for gas sensing applications. In the FEA simulation, frequency domain analysis was performed to enhance the performance of the acoustic resonator. The structural and surface morphologies of the deposited ZnO as a piezoelectric layer have been studied using XRD and AFM. The XRD pattern of deposited bulk ZnO film indicates the perfect single crystalline nature of the film with dominant phase (002) at 2θ = 34.58°. The AFM micrograph indicates that deposited piezoelectric film has a very smooth surface and small grain size. In the fabrication process, use of bulk micro machined oxide (SiO2) for the production of a thin membrane as a support layer is adopted. A vector network analyzer (Model MS2028C, Anritsu) was used to measure the radio frequency response of the resonators from 1 GHz to 2.5 GHz. As a result, we have successfully fabricated an acoustic resonator operating at 1.84 GHz with a quality factor Q of 214 and an effective electromechanical coupling coefficient of 10.57%.