This study employs an innovative dynamic switching test system to investigate the dynamic switching characteristics of three p-GaN HEMT devices. The dynamic switching characteristics are different from the previous research on the dynamic resistance characteristics of GaN devices, and the stability of GaN devices can be analyzed from the perspective of switching characteristics. Based on the theory of dynamic changes in threshold opening voltage and capacitance caused by electrical stress, the mechanism of dynamic switching characteristics of GaN HEMT devices is studied and analyzed in detail. The test results have shown that electrical stress induces trap ionization within the device, resulting in fluctuations in electric potential and ultimately leading to alterations in two critical factors of the dynamic switching characteristics of GaN HEMT devices, the parasitic capacitance and the threshold voltage. The dynamic changes in capacitance before and after electrical stress vary among devices, resulting in different dynamic switching characteristics. The test system is capable of extracting the switching waveform for visual comparison and quantitatively calculating the changes in switching parameters before and after electrical stressing. This test provides a prediction for the drift of switch parameters, offering pre-guidance for the robustness of the optimized application scheme.
In this article, a dedicated testing system is developed to realize low-delay threshold voltage (VTH) characteristic testing of silicon carbide (SiC) MOSFET devices after an avalanche stress. The developed low-delay testing system enables VTH detection within milliseconds after the avalanche, facilitating the study of VTH drift behavior under different gate-source turn-off voltages (VGS-OFF) and repeated avalanche events. Experimental results of 1200 V commercial devices indicate that after a single avalanche stress, VTH drifts positively by about 0.11 V when VGS-OFF is 0 V. However, if the avalanche stress is monitored at a negative bias of VGS-OFF, VTH exhibits a negative drift. The drift increases as a more negative gate bias is applied. When VGS-OFF reaches 6 V, the VTH drift saturates at approximately −0.226 V. After repeated avalanche cycles, the threshold drift does not saturate until VGS-OFF is −10 V. Furthermore, verification shows that the VTH drift is minimized when VGS-OFF is −3 V. The absolute value of VTH drift shows a non-monotonic variation with avalanche cycles: it starts to increase with the number of avalanche cycles, reaching a peak at approximately 1000 cycles, and further increasing the avalanche cycles. The magnitude of the drift gradually decreases after reaching a peak. TCAD simulations reveal that this phenomenon could be attributed to the ionization of donor/acceptor traps at the SiC/SiO2 interface and the consequent modulation of channel hole concentration. After excitation by electric fields of varying intensities, the ionization of acceptor and donor traps undergoes differential changes, consequently leading to a non-monotonic drift in threshold voltage.