The melt flow, level fluctuation, temperature field, and solidification behavior coupled with electromagnetic stirring (EMS) effects in the continuous casting mold region of U71Mn steel bloom were numerically analyzed by commercial computational fluid dynamics (CFD) software named ANSYS FLUENT. The effects of submerged entry nozzle (SEN) structures and the installation methods for optimized four-port SEN on the flow pattern, level fluctuation, heat transfer and initial solidification behavior in a bloom mold loaded with EMS were investigated. The aim is to propose a better SEN condition for the big bloom casting of high railway steel. The water simulation experiments were conducted to show the flow characteristics under different SEN conditions and verify the numerical model of flow pattern. The experimental and numerical simulation results showed that the optimized four-port SEN with diagonal installation cannot only improve the flow pattern of the molten steel by alleviating the level fluctuation and reducing the impact pressure to the wall. It is also beneficial for temperature variation at both bloom surface and corner, as well as the local solidified shell thinning phenomena due to the elimination of impingement effect.

The flow, temperature, solidification, and solute concentration field in a continuous casting bloom mold were solved simultaneously by a multiphysics numerical model by considering the effect of in-mold electromagnetic stirring (M-EMS). The mold metallurgical differences between cases with and without EMS are discussed first, and then the solute transport model verified. Moreover, the effects of EMS current intensity on the metallurgical behavior in the bloom mold were also investigated. The simulated solute distributions were basically consistent with the test results. The simulations showed that M-EMS can apparently homogenize the initial solidified shell, liquid steel temperature, and solute element in the EMS effective zone. Meanwhile, the impingement effect of jet flow and molten steel superheat can be reduced, and the degree of negative segregation in the solidified shell at the mold corner alleviated from 0.74 to 0.78. However, the level fluctuation and segregation degree in the shell around the center of the wide and narrow sides were aggravated from 4.5 mm to 6.2 mm and from 0.84 to 0.738, respectively. With the rise of current intensity the bloom surface temperature, level fluctuation, stirring intensity, uniformity of molten steel temperature, and solute distribution also increased, while the growth velocity of the solidifying shell in the EMS effective zone declined and the solute mass fraction at the center of the computational outlet (z = 1.5 m) decreased. M-EMS with a current intensity of 600 A is more suitable for big bloom castings.

In most cases, arsenic is an unfavorable element in metallurgical processes. The mechanism of arsenic removal was investigated through roasting experiments performed on arsenopyrite-bearing iron ore. Thermodynamic calculation of arsenic recovery was carried out by FactSage 7.0 software (Thermfact/CRCT, Montreal, Canada; GTT-Technologies, Ahern, Germany). Moreover, the arsenic residues in dust ash were recovered by roasting dust ash in a reducing atmosphere. Furthermore, the corresponding chemical properties of the roasted ore and dust ash were determined by X-ray diffraction, inductively coupled plasma atomic emission spectrometry, and scanning electron microscopy, coupled with energy-dispersive X-ray spectroscopy. The experimental results revealed that the arsenic in arsenopyrite-bearing iron ore can be removed in the form of As₂O₃(g) in an air or nitrogen atmosphere by a roasting method. The efficiency of arsenic removal through roasting in air was found to be less than that in nitrogen atmosphere. The method of roasting in a reducing atmosphere is feasible for arsenic recovery from dust ash. When the carbon mass ratio in dust ash is 1.83%, the arsenic removal products is almost volatilized and recovered in the form of As₂O₃(g).