This paper presents the design of an ultrabroadband solar absorber, developed using a metamaterial stack composed of only two materials, consisting of alternating layers of Cr and SiO2. Starting with a Cr layer as the substrate, multiple pairs of Cr and SiO2 were stacked sequentially, where one Cr layer and one SiO2 layer constitute a single pair. To further enhance performance, a cylindrical Cr structure was added to the top. A key innovation of this work lay in its material simplicity and cost efficiency, relying solely on two inexpensive materials, Cr and SiO2. Additionally, the inclusion of the top Cr cylinder was found to significantly enhance absorptivity. Simulations demonstrate that removing this feature led to a noticeable reduction in absorptivity of approximately 10% across the 500–2000 nm wavelength range. Another important finding is the effect of the number of Cr–SiO2 pairs on absorption behavior. When the number of pairs increases from four to five, the average absorptivity decreases slightly, but the absorption bandwidth is notably broadened. Further increasing six pairs resulted in a marginal increase in bandwidth, while maintaining the average absorptivity. Moreover, a low-absorptivity dip at 360 nm was slightly mitigated, rising to approximately 0.900. Based on these insights, a six-pair metamaterial structure was chosen for further optimization. Utilizing COMSOL Multiphysics® simulation software (version 6.0), the absorber was successfully engineered to achieve high performance across an exceptionally broad spectral range, from 200 nm to 2160 nm. Under optimal design parameters, it exhibited an average absorptivity of 0.950, with absorptivity consistently exceeding 0.900 throughout this range. This demonstrates the absorber’s strong potential for efficient solar energy harvesting using a structurally simple and cost-effective design.
In this study, an ultra-wideband absorber spanning from UV-B to middle-IR was designed and analyzed using a novel structure. The multilayer metamaterial, arranged from bottom to top, consisted of an Al metal layer, a lower SiO2 layer, a graphite layer, another SiO2 layer, a thin Ti layer, and a top SiO2 layer. The top layer of SiO2 had a 200 nm square cavity etched out, and then a square Ti nanopillar and a square Ti hollow outside a Ti nanopillar were embedded. This specific arrangement was chosen to maximize the absorption properties across a broad spectrum. The absorption spectrum of the designed absorber was thoroughly analyzed using the commercial finite element analysis software COMSOL Multiphysics® (version 6.0). This analysis confirmed that the combination of these various components achieved perfect absorption and an ultra-wideband response. The synergistic interaction between the layers and the nanopillars structure contributed significantly to the absorber’s efficiency, making it a promising candidate for applications requiring broad-spectrum absorption. The comprehensive analyses of the parameters for different structures demonstrated that the effects of guided-mode resonance, coupling resonance, optical impedance matching, and propagating surface plasmon resonance existed in the investigated structure. The optimal model, determined through analyses using COMSOL Multiphysics®, showed that the broadband absorption in the range of 270 to 3600 nm, spanning from UV-B to middle-IR, exceeded 90.0%. The average absorption rate within this range was 0.967, with the highest reaching a near-perfect absorptivity of 99.9%. We also compared three absorption spectra in this study: the t1–t6 flat structure, the t1–t5 flat structure with t6 featuring a square cavity, and the structure proposed in this study. This demonstrates that a square nanopillar and a square hollow embedded in a square cavity can enhance the absorptive properties of the absorber.