This paper presents the design of an ultrabroadband solar absorber, developed using a metamaterial stack composed of only two materials, consisting of alternating layers of Cr and SiO2. Starting with a Cr layer as the substrate, multiple pairs of Cr and SiO2 were stacked sequentially, where one Cr layer and one SiO2 layer constitute a single pair. To further enhance performance, a cylindrical Cr structure was added to the top. A key innovation of this work lay in its material simplicity and cost efficiency, relying solely on two inexpensive materials, Cr and SiO2. Additionally, the inclusion of the top Cr cylinder was found to significantly enhance absorptivity. Simulations demonstrate that removing this feature led to a noticeable reduction in absorptivity of approximately 10% across the 500–2000 nm wavelength range. Another important finding is the effect of the number of Cr–SiO2 pairs on absorption behavior. When the number of pairs increases from four to five, the average absorptivity decreases slightly, but the absorption bandwidth is notably broadened. Further increasing six pairs resulted in a marginal increase in bandwidth, while maintaining the average absorptivity. Moreover, a low-absorptivity dip at 360 nm was slightly mitigated, rising to approximately 0.900. Based on these insights, a six-pair metamaterial structure was chosen for further optimization. Utilizing COMSOL Multiphysics® simulation software (version 6.0), the absorber was successfully engineered to achieve high performance across an exceptionally broad spectral range, from 200 nm to 2160 nm. Under optimal design parameters, it exhibited an average absorptivity of 0.950, with absorptivity consistently exceeding 0.900 throughout this range. This demonstrates the absorber’s strong potential for efficient solar energy harvesting using a structurally simple and cost-effective design.
In the development of optical absorption technology, achieving ultra-wideband high absorption structures that span from the 200 nm ultraviolet C region to the 5800 nm mid-infrared range has been a significant challenge in materials science. Previous studies have shown that few optical absorbers can simultaneously achieve an absorption rate above 0.900 and cover such a vast spectral range. This study presents an innovative seven-layer composite structure that successfully addresses this long-standing technical issue. Through a carefully designed layered architecture, the researchers employed COMSOL Multiphysics (version 6.0) for detailed numerical simulations to verify the optical performance of the structure. The structural design features two key innovations. In the layered composition, the bottom (h1), h3, and h5 layers are made of metallic Fe, while the layers above them (h2, h4, and h6) use SiO2. The top layer is composed of a discontinuous cylinder Ti matrix. The first innovation involves the use of an inwardly recessed square design on the metallic Fe planes of the h4 and h6 layers, achieving high absorption across the 600–5800 nm range. The second innovation involves the use of the discontinuous cylinder Ti matrix for the top layer, which successfully enhances absorption performance in the 200–600 nm wavelength range. This structure not only employs relatively low-cost metals and oxide materials but also demonstrates significant optical absorption potential. Through numerical simulations and precise structural design, this study provides new ideas and technological pathways for the development of ultra-wideband optical absorbers.