Anis Shofiyani

Dr. Anis Shofiyani


Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
15 October 2022 in Indonesian Journal of Chemistry
Verified
Journal Article
Open access
PDF file
WRWinda Rahmalia
Winda Rahmalia
ASAnis Shofiyani
Anis Shofiyani
YSYohana Sutiknyawati
Yohana Sutiknyawati
SSSeptiani Septiani
Septiani Septiani
Bixin is a natural dye belonging to the carotenoid group that has been reported to have many health benefits. In this work, for the first time, metal-bixin complexes were synthesized through a simple green route using deep eutectic solvent (DES) as reaction media. DES was produced by stirring choline chloride and glycerol with a molar ratio of 1:3. The metal-bixin complex was prepared by grinding and stirring bixin and divalent metal ions (Mg2+, Ca2+, Zn2+, Cu2+, separately) in DES at room temperature. DES formed in this work was a homogeneous colorless liquid with a freezing point below -20 °C. It has a pH, density, viscosity, and conductivity of 7.13, 148.99 cP, 1.207 g/cm3, and 1.8 mS/cm, respectively. UV-Vis spectrophotometric analysis shows that the absorption spectra produced by the Mg(II)-bixin, Ca(II)-bixin, Zn(II)-bixin, and Cu(II)-bixin complexes show an insignificant shift in the direction of a larger wavelength (red shift) compared to pure bixin. Spectral fine structure expressed as %III/II, i.e., the ratio of the height of the longest-wavelength absorption to the middle absorption peak. The value of %III/II for bixin, Mg(II)-bixin, Ca(II)-bixin, Zn(II)-bixin, and Cu(II)-bixin are 16.77, 20.37, 17.39, and 13.52%, respectively. The results of the FTIR spectra analysis confirmed that the bond between bixin and metal ions occurred in the carboxylate acid group, indicated by a decrease in the absorption intensity at wavenumber 3389 and 1716 cm−1.

27 June 2020 in Jurnal Kimia Sains dan Aplikasi
Verified
Journal Article
Open access
PDF file
STSellen Tanheitafino
Sellen Tanheitafino
ASAnis Shofiyani
Anis Shofiyani
RSRisya Sasri
Risya Sasri
RRRudiyansyah Rudiyansyah
Rudiyansyah Rudiyansyah
Modification of silica xerogel with TMCS (trimethylchlorosilane) reagent has been carried out to improve the hydrophobicity of silica xerogel. Silica xerogel was synthesized based on the sol-gel method using sodium silicate as a precursor, and citric acid as a catalyst, with a mole ratio of sodium silicate and citric acid, was 0.172: 0.004. The sol-gel process was carried out through several stages, i.e., hydrolysis and condensation of sodium silicate to form sol, gelation (sol transition to gel), aging, and drying. Surface modification was performed by studying the effect of TMCS: methanol: petroleum benzine volume ratio of 0.5:1:1, 1:1:1, 1.5:1:1, 2:1:1, and 2.5:1:1 on the characteristics of silica xerogel synthesized. FTIR, SEM, and GSA characterized the synthesized results. The results of FTIR characterization on silica xerogel with volume ratios of 2:1:1 and 2.5:1:1 indicate the presence of the Si‑C group absorption at a wavenumber of 848.68 cm-1 which shows that the formation of silyl groups on the modified silica xerogel surfaces occurs at a TMCS: methanol: petroleum benzine ratio of 2:1:1 and 2.5:1:1. SEM results indicate that the silica xerogels produced are porous. Meanwhile, the GSA analysis results show that the pore size distributions are in the mesoporous region with an average pore radius of 8-13 nm. The greater the volume of TMCS used, the higher the surface area, and the resulting xerogel’s hydrophobicity. Based on the contact angle and seeped time test, the highest hydrophobicity is produced by the material synthesized at a TMCS: methanol: PB volume ratio of 2.5:1:1 with a contact angle of 116.346°.

1 August 2024 in Indonesian Journal of Chemistry
Verified
Journal Article
Open access
PDF file
WRWinda Rahmalia
Winda Rahmalia
ASAnis Shofiyani
Anis Shofiyani
YDYohana Sutiknyawati Kusuma Dewi
Yohana Sutiknyawati Kusuma Dewi
FIFani Indriani
Fani Indriani
APAlintianni Yolla Putri
Alintianni Yolla Putri
SSSeptiani Septiani
Septiani Septiani
Bixin is used in wide-ranging food applications but is susceptible to degradation by many factors, including light. This research aims to increase bixin photostability through metal complexation. Bixin was complexed with Mg2+, Ca2+, Zn2+, and Se4+. The synthesis process was carried out in deep eutectic solvent media. Metal-bixin complexes have been successfully synthesized, indicated by the change in retention factor and %III/II ratio values resulting from thin-layer chromatography and UV-vis spectrophotometer analysis, respectively. The Fourier transform infrared analysis showed the interaction between central metal ion with bixin ligand has occurred by hydroxyl and carbonyl groups of bixin, which was characterized by a decrease in the intensity of the absorption peak in wavenumber 3000–4000 cm−1 (for the –OH carboxylic group vibration) and the peak shift of metal-bixin complexes towards the larger compared to bixin in the range wavenumber 1600–1700 cm−1 (for C=O ester vibrations). First-order photodegradation kinetics studies showed that the metal-bixin complexes were more stable than pure bixin. Se-bixin was four times more stable than pure bixin. Complexation of bixin with metals was shown to be a potential method to increase the stability of bixin, especially against light exposure.

22 January 2019 in Jurnal ILMU DASAR
Verified
Journal Article
Open access
PDF file
ASAnis Shofiyani
Anis Shofiyani
FCFara Chitra
Fara Chitra
WRWinda Rahmalia
Winda Rahmalia
RRR. Rudiyansyah
R. Rudiyansyah
AAAndi Hairil Alimuddin
Andi Hairil Alimuddin
Padas stone is one of the natural mineral containing 67.5% of SiO2 compounds. In this research, synthesis of nanosilica was carried out by sol-gel method asistanced by 2.45 GHz microwave radiations with low (10%), medium (50%) and high (100%) power at 30 and 60 minutes of contact times. It was analyzed by XRD, BET, FTIR spectrophotometry and SEM. The synthesized silica was then used as absorbent for total organic carbon (TOC) of palm oil waste. The results show that the synthesized silica was a mixture of cristobalite and quartz type minerals according to ICDD No. 00-003-0271 and 01-083-287. The surface area and silicon dioxide contains are 12.174 m2/g and 76.325% for silica without microwave assistance (SiO2-TPMW); 12.796 m2/gand 86.385% for silica with 30 minutes on 10% microwave assistance(SiO2 -MW 10A); 12.735 m2/gand 86.254% for silica with 60 minutes on 10% microwave assistance (MW 10B); 13,659 m2/gand 87.211% for MW 50A; 13,583 m2/g and 86.684% for MW 50B;7.883 m2/gand 57.527% for MW 100A; also 8.752 m2/g and 37.725% for MW 100B, respectively. The use of silica as an absorbent of TOC shows the effectiveness of 62.89% (TPMW); 63.68% (MW 10A); 62.96% (MW 10B); 65.25% (MW 50A); 64.61% (MW 50B); 62.37% (MW 100A) and 61.18% (MW 100B) from the initial TOC of 1520 mg/L. Keywords: synthesis, nanosilica, padas stone, total organic carbon, oil waste.

28 May 2024 in Jurnal Kimia Sains dan Aplikasi
Verified
Journal Article
Open access
PDF file
LSLisa Sari
Lisa Sari
ASAnis Shofiyani
Anis Shofiyani
ASAjuk Sapar
Ajuk Sapar
Composites are synthesized by combining different materials, resulting in properties suitable for use as adsorbents due to the combination of pores and functional groups within the constituent materials. This study developed a silica-biochar composite to serve as an adsorbent for rhodamine B dye, utilizing silica derived from red mud and biochar obtained from oil palm empty fruit bunches (OPEFB). This research focused on analyzing the characteristics and effectiveness of the composite as an adsorbent by varying its composition. Silica from red mud exhibited a purity of 80.05% and possessed silanol (Si-OH) and siloxane (Si-O-Si) functional groups on its surface, whereas biochar from OPEFB had a carbon content of 95.91% and included functional groups such as -OH, C=O, C=C, C-H, and C-O. The combination of silica and biochar yielded a composite surface consisting of -OH, C=O, C=C, C-O, C-H, and Si-O-Si functional groups. The silica-biochar composite demonstrated a greater surface area than its individual components, with silica at 69.824 m²/g and biochar at 95.452 m²/g. The composite with a 1:2 (% w/w) ratio exhibited the largest surface area at 102.371 m²/g, achieving a maximum adsorption capacity of 1.550 mg/g and an efficiency of 88.463%. The adsorption process encompasses physical interactions via pore diffusion and chemical interactions through functional groups.

31 May 2023 in POSITRON
Verified
Journal Article
Open access
PDF file
NENur Eviva
Nur Eviva
ASAnis Shofiyani
Anis Shofiyani
ESEndah Sayekti
Endah Sayekti
Red mud is a bauxite industrial waste of reddish-brown mud with high alkalinity. Red mud has relatively high silica and alumina content, so it can be utilized as a raw material in the synthesis of zeolite. This study aims to synthesize high-purity NaP zeolite from red mud at various SiO2/Al2O3 mole ratios. The synthesis begins with neutralizing the red mud, followed by decomposition using the alkaline fusion method at a ratio of red mud:NaOH = 1:1 (w/w). The filtrate produced by the alkaline fusion was adjusted to the mole ratio of SiO2/Al2O3 = 2.0; 2.5; 3.0; and 4.0, respectively, by adding sodium silicate, followed by a hydrothermal process using an autoclave at 120oC for 16 hours. The synthesized zeolites were characterized using XRD and FTIR spectrophotometry. The XRD results showed that the zeolite produced in all variations of the SiO2/Al2O3 mole ratio studied was a type of high-purity NaP with no other zeolite crystalline phases found as impurities. The structure formed is tetragonal with a degree of crystallinity of 74.54%; 76.47%; 78.94%; 75.64%, and crystal size 80.2286; 54.3437; 37.7099 and 40.1226 nm for zeolite with SiO2/Al2O3 mole ratio 2.0; 2.5; 3.0; and 4.0, respectively. Based on the results of the study, pure NaP zeolite can be synthesized from red mud material using the hydrothermal method at the ratio of moles SiO2/Al2O3 = 2.0 – 4.0.