Winda Rahmalia

Winda Rahmalia

Auto-generated profile, based on publicly available information

Winda Rahmalia

Department of Chemistry, Faculty of Mathematics and Natural Science, Universitas Tanjungpura, Indonesia

Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 October 2014 in Spectrochimica Acta Part A: Molecular and Biomolecular Spectroscopy
Verified
Journal Article
Closed access
WRWinda Rahmalia
Winda Rahmalia
JFJean-François Fabre
Jean-François Fabre
TUThamrin Usman
Thamrin Usman
ZMZéphirin Mouloungui
Zéphirin Mouloungui

15 July 2025 in Journal of Molecular Structure
Verified
Journal Article
Closed access
ASAsep Saefumillah
Asep Saefumillah
DADewangga Oky Bagus Apriandanu
Dewangga Oky Bagus Apriandanu
RRRafi Ramadhan
Rafi Ramadhan
RFRahma Demy Fitria
Rahma Demy Fitria
YYYoki Yulizar
Yoki Yulizar
AAAndi Hairil Alimuddin
Andi Hairil Alimuddin

15 October 2022 in Indonesian Journal of Chemistry
Verified
Journal Article
Open access
PDF file
WRWinda Rahmalia
Winda Rahmalia
ASAnis Shofiyani
Anis Shofiyani
YSYohana Sutiknyawati
Yohana Sutiknyawati
SSSeptiani Septiani
Septiani Septiani
Bixin is a natural dye belonging to the carotenoid group that has been reported to have many health benefits. In this work, for the first time, metal-bixin complexes were synthesized through a simple green route using deep eutectic solvent (DES) as reaction media. DES was produced by stirring choline chloride and glycerol with a molar ratio of 1:3. The metal-bixin complex was prepared by grinding and stirring bixin and divalent metal ions (Mg2+, Ca2+, Zn2+, Cu2+, separately) in DES at room temperature. DES formed in this work was a homogeneous colorless liquid with a freezing point below -20 °C. It has a pH, density, viscosity, and conductivity of 7.13, 148.99 cP, 1.207 g/cm3, and 1.8 mS/cm, respectively. UV-Vis spectrophotometric analysis shows that the absorption spectra produced by the Mg(II)-bixin, Ca(II)-bixin, Zn(II)-bixin, and Cu(II)-bixin complexes show an insignificant shift in the direction of a larger wavelength (red shift) compared to pure bixin. Spectral fine structure expressed as %III/II, i.e., the ratio of the height of the longest-wavelength absorption to the middle absorption peak. The value of %III/II for bixin, Mg(II)-bixin, Ca(II)-bixin, Zn(II)-bixin, and Cu(II)-bixin are 16.77, 20.37, 17.39, and 13.52%, respectively. The results of the FTIR spectra analysis confirmed that the bond between bixin and metal ions occurred in the carboxylate acid group, indicated by a decrease in the absorption intensity at wavenumber 3389 and 1716 cm−1.

18 January 2018 in Bioinorganic Chemistry and Applications
Verified
Journal Article
Open access
PDF file
WRWinda Rahmalia
Winda Rahmalia
JFJean-François Fabre
Jean-François Fabre
TUThamrin Usman
Thamrin Usman
ZMZéphirin Mouloungui
Zéphirin Mouloungui
The adsorption of bixin in aprotic solvents onto acid- and alkali-treated kaolinite was investigated. Kaolinite was treated three times, for 6 h each, with 8 M HCl or 5 M KOH. The adsorbents were characterized by XRD, FT-IR, EDS, and BET-N2. The effects of contact time and dye concentration on adsorption capacity and kinetics, electronic transition of bixin before and after adsorption, and also mechanism of bixin-kaolinite adsorption were investigated. Dye adsorption followed pseudo-second order kinetics and was faster in acetone than in dimethyl carbonate. The best adsorption results were obtained for KOH-treated kaolinite. In both of the solvents, the adsorption isotherm followed the Langmuir model and adsorption capacity was higher in dimethyl carbonate (qm = 0.43 mg/g) than in acetone (0.29 mg/g). The adsorption capacity and kinetics of KOH-treated kaolinite (qm = 0.43 mg/g,k2 = 3.27 g/mg·min) were better than those of HCl-treated kaolinite (qm = 0.21 mg/g,k2 = 0.25 g/mg·min) and natural kaolinite (qm = 0.18 mg/g,k2 = 0.32 g/mg·min). There are shift in the band position of maximum intensity of bixin after adsorption on this adsorbent. Adsorption in this system seemed to be based essentially on chemisorption due to the electrostatic interaction of bixin with the strong basic and reducing sites of kaolinite.

1 April 2021 in Indonesian Journal of Chemistry
Verified
Journal Article
Open access
PDF file
WRWinda Rahmalia
Winda Rahmalia
SSSeptiani Septiani
Septiani Septiani
UNUray Amira Naselia
Uray Amira Naselia
TUThamrin Usman
Thamrin Usman
ISImelda Hotmarisi Silalahi
Imelda Hotmarisi Silalahi
ZMZéphirin Mouloungui
Zéphirin Mouloungui
Bixin is one of the potential natural sensitizers used in dye-sensitized solar cells (DSSCs). In this study, bixin was complexed with Cu(II) and Zn(II) to increase its stability. The formation of the complexes was indicated by shifting peaks absorption and the changes in the fine spectral structure observed from the UV-Vis absorption spectra. The metal-bixin complex occurs due to the interaction between the ester groups of bixin and the metal. Bixin, Cu-bixin, and Zn-bixin were used separately as sensitizers in DSSCs. The DSSCs performance was then improved by adding 1-methyl-3-propylimidazolium iodide (MPII) to the electrolyte system. The presence of MPII 0.4 M in KI-I2 electrolyte produced a higher ionic conductivity value (20.44 mS cm–1) than that without MPII (11.14 mS cm–1). This electrolyte system significantly improved DSSCs performance. Under a light intensity of 300 W/m2, the maximum energy conversion efficiencies of DSSC with bixin, Cu-bixin, and Zn-bixin as sensitizers are 0.084, 0.081, and 0.005%, respectively. The Zn-bixin-based DSSC was stable under high light intensity. Under 700 W/m2, its maximum energy conversion efficiency reaches 0.125%. There was a synergistic work observed between the metal-bixin complex and the MPII based electrolyte. This result can open the way for constructing functional materials for solar cell applications.

3 June 2021 in Materials for Renewable and Sustainable Energy
Verified
Journal Article
Open access
PDF file
WRWinda Rahmalia
Winda Rahmalia
ISImelda Hotmarisi Silalahi
Imelda Hotmarisi Silalahi
TUThamrin Usman
Thamrin Usman
JFJean-François Fabre
Jean-François Fabre
ZMZéphirin Mouloungui
Zéphirin Mouloungui
GZGeorges Zissis
Georges Zissis
In this research, treated metakaolinite (TMK) was introduced into the TiO2 photoelectrode to fabricated dye-sensitized solar cells (DSSCs). The photovoltaic cells have four main natural components, i.e., a photosensitizer (carotenoid bixin), photoelectrode (TiO2/kaolinite), electrolyte (glycerine carbonate derivative), and counter-electrode (carbon). Their stability, reusability, and equivalent circuit were studied. The presence of 5% of TMK in anatase TiO2 paste decreased the TiO2 band gap from 3.21 to 3.16 eV. The result showed that the presence of 5% of TMK in TiO2 paste was more favorable to obtain higher energy conversion efficiency. Under a light intensity of 200 W/m2, it produced an energy conversion yield of 0.086%. The combination of the electrolyte and the TMK demonstrated a synergistic effect to improve the electrical properties of the DSSC. The energy storage function worked well until the third day of analysis. The DSSC based on TiO2/TMK photoelectrode exhibited 16 times better stability than pure TiO2-based photoelectrode. The Faraday charge transfer processes showed that the TiO2/TMK photoelectrode is not in direct contact with the carbon counter-electrode.