Xiang Zhang

Dr. Xiang Zhang

orcid

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
27 September 2023 in Energies
Verified
Journal Article
Open access
PDF file
CYChen Yang
Chen Yang
YLYong Liu
Yong Liu
XZXiang Zhang
Xiang Zhang
HLHao Li
Hao Li
XGXinkun Ge
Xinkun Ge
CLChongyang Liu
Chongyang Liu
Non-premixed swirl combustion has been widely used in pieces of industrial combustion equipment such as industrial boilers, furnaces, and certain specific gas turbine combustors. In recent years, the combustion instability of non-premixed swirl flames has begun receiving attention, yet there is still a lack of related research in academia. Therefore, in this study, we conducted experimental research on a swirl stabilized gas flame model combustor and studied the heat release response characteristics of the swirl combustor through the flame transfer function. Firstly, the flame transfer function (FTF) was measured under different inlet velocities and equivalence ratios, and the experimental results showed that the FTF gain curve of the non-premixed swirl flame exhibited a significant “bimodal” shape, with the gain peaks located around 230 Hz and 330 Hz, respectively. Secondly, two oscillation modes of the flame near the two gain peaks were identified (the acoustic induced vortex mode Mv and the thermoacoustic oscillation mode Ma), which have not been reported in previous studies on swirl non-premixed flames. In addition, we comprehensively analyzed the flame pulsation characteristics under the two oscillation modes. Finally, the coupling degrees between velocity fluctuations, fuel pressure fluctuations, and heat release fluctuations were analyzed using the Rayleigh Index (RI), and it was found that in the acoustic-induced vortex mode, a complete feedback loop was not formed between the combustor and the fuel pipeline, which was the main reason for the significant difference in the pressure fluctuation amplitude near 230 Hz and 330 Hz.

27 November 2022 in Energies
Verified
Journal Article
Open access
PDF file
JHJiangang Hao
Jiangang Hao
YDYang Ding
Yang Ding
CYChen Yang
Chen Yang
XWXuhuai Wang
Xuhuai Wang
XZXiang Zhang
Xiang Zhang
FJFeng Jin
Feng Jin
In this paper, the effect of the swirler scheme on combustion instability is studied. Through the proper orthogonal decomposition (POD) of flame images, Abel inverse transform and other methods, the influence of swirl intensity on the characteristic frequency of combustion instability was emphatically studied. Based on the low order thermoacoustic network (LOTAN) of the combustor, the flame transfer function (FTF) under different swirl schemes was obtained by the optimization method. The experimental results show that the stable combustion equivalence ratio boundary of the system decreases monotonously with the decrease in swirl intensity, while the characteristic frequency of unstable combustion is not monotonous with the swirl intensity (the oscillating frequency of swirler A with the largest swirl intensity is approximately 319 Hz, swirler B is approximately 280 Hz, swirler C with the smallest swirl intensity is approximately 290 Hz). The optimization results of FTF can easily introduce this non monotonic phenomenon. The swirl intensity mainly affects the hysteresis time of the system (the lag time of swirlers A, B and C are 5.98 ms, 6.82 ms and 6.20 ms, respectively), which is mainly caused by affecting the flame structure and convection velocity. At the same time, the FTF obtained by optimization reflects the same trend with the experimental results, and there is no significant difference in value, which proves the rationality of the optimization method. This work emphasizes the importance of FTF for combustion instability analysis.

27 July 2022 in Sensors
Verified
Journal Article
Open access
PDF file
XWXuhuai Wang
Xuhuai Wang
XZXiang Zhang
Xiang Zhang
CYChen Yang
Chen Yang
HLHao Li
Hao Li
YLYong LIU
Yong LIU
In order to study the characteristics of pressure fluctuation during unstable combustion, experimental studies had been conducted on the mechanism model of the swirl combustor and the industrial swirl combustor. The signal of dynamic pressure, heat release rate, and the high-speed flame image in the two combustors were synchronously collected by using dynamic pressure sensors, a photoelectric sensor, and a high-speed camera under normal temperature and pressure. After empirical mode decomposition of the dynamic pressure signal, several intrinsic mode functions were obtained. It was found that the pressure pulsation energy is concentrated in the first three order intrinsic mode function. Through fast Fourier transform spectrum calculation, it was found that the first three order intrinsic mode function pulsation can characterize the changes of heat release rate and air flow pulsation under cold state and flame instability. It showed that the decomposition of the dynamic pressure in the combustor by this method can obtain the main physical processes in its connotation, and provide data processing methods for the induction mechanism of oscillating combustion and combustion diagnosis in an industrial combustor test.

21 August 2024 in Energies
Verified
Journal Article
Open access
PDF file
CLChongyang Liu
Chongyang Liu
XGXinkun Ge
Xinkun Ge
XZXiang Zhang
Xiang Zhang
CYChen Yang
Chen Yang
YLYong Liu
Yong Liu
This study focuses on the center-staged swirl model combustion chamber, conducting experiments and numerical simulations to investigate the unstable combustion characteristics of diffusion flames under different Reynolds numbers and air–fuel ratios. The results were analyzed using methods such as Empirical Mode Decomposition (EMD), Fast Fourier Transform (FFT), and Proper Orthogonal Decomposition (POD). The research found that the first three intrinsic mode functions (IMFs) of the combustion chamber pressure fluctuation signal (DP) correspond to different physical fluctuation characteristics. Specifically, the 1st IMF represents the fluctuation characteristics of the heat release rate, corresponding to the flame shear region in the heat release rate field; the 2nd IMF represents the fluctuation characteristics of airflow swirl, corresponding to the swirl vortex structure region in the vorticity field; the 3rd IMF represents the flame detachment fluctuation characteristics, corresponding to the flame detachment region in the heat release rate field. Using the same experimental and numerical calculation methods to study another swirl model combustion chamber, the results also showed the aforementioned correspondence, further demonstrating the accuracy of the experimental results and the universality of this conclusion.

1 March 2025 in Physics of Fluids
Verified
Journal Article
Closed access
XZXiang Zhang
Xiang Zhang
SWSuofang Wang
Suofang Wang
YLYong Liu
Yong Liu
This paper investigates the thermoacoustic stability of non-premixed flames in a tangential swirler combustion chamber. Thermoacoustic instabilities, characterized by intense pressure oscillations, pose significant challenges in the design and operation of combustion devices such as gas turbines and rocket engines. This study focuses on understanding the dynamics of flame heat release rate (HRR) and its interaction with acoustic waves under varying operating conditions. The experimental setup involves a single-injector tangential swirler non-premixed flame with detailed measurements of pressure fluctuations, HRR, and flame dynamics using high-speed imaging and chemiluminescence techniques. The results reveal distinct thermoacoustic instability modes, influenced by factors such as inlet velocity and equivalence ratio. This paper highlights the complex interplay between flame structure, HRR fluctuations, and acoustic coupling, providing insight into the mechanisms that govern thermoacoustic stability in non-premixed combustion systems. This research contributes to the development of strategies for mitigating thermoacoustic instabilities in practical combustion applications.

27 July 2022 in Energies
Verified
Journal Article
Open access
PDF file
YDYang Ding
Yang Ding
JHJiangang Hao
Jiangang Hao
ALAnqi Li
Anqi Li
XWXuhuai Wang
Xuhuai Wang
XZXiang Zhang
Xiang Zhang
YLYong Liu
Yong Liu
The annual operation data of an F-class gas turbine generator set revealed that the duration of the startup process accounts for about 8.5% of the whole operation process. The three combustion models of a DLN2.0+ combustor demonstrated higher NOx emissions than the premixed mode under normal load during the startup process. In order to evaluate the scale of NOx emissions at this stage, numerical simulation was carried out for the startup process to discern the NOx emission pattern. Typical simulation conditions for each season were established to calculate the total annual NOx emissions at the initial stage based on operating data. On this basis, the characteristics of NOx emissions influenced by changes in the atmospheric environment were studied in depth. The results of this study provide referential data for evaluating the pollution characteristics and combustion adjustment of a ground gas turbine during startup.