Bismuth ferrite (BiFeO3, BFO) is one of the few single-phase crystalline compounds exhibiting strong multiferroic properties at room temperature, which makes it promising for use in various fields of science and technology. The remarkable characteristics of BFO at the nanoscale position it as a compelling candidate for enhancing the functionalities of polymeric nanocomposite materials. In this study, we explore the fabrication of polyvinylidene fluoride (PVDF) nanocomposites with a variable content of BFO nanopowders (0, 5, 10, 15, 20, and 25 wt%) by solution casting in the form of thin films with the thickness of ~60 µm. Our findings reveal that the presence of BFO nanoparticles slightly facilitates the formation of β- and γ-phases of PVDF, known for their enhanced piezoelectric properties, thereby potentially expanding the utility of PVDF-based materials in sensors, actuators, and energy harvesting devices. On the other hand, the increase in filler concentration leads to enlarged spherulite diameter and porosity of PVDF, as well as an increase in filler content above 20 wt% resulting in a decrease in the degree of crystallinity. The structural changes in the surface were found to increase the hydrophobicity of the nanocomposite surface. Magnetometry indicates that the magnetic properties of nanocomposite are influenced by the BFO nanoparticle content with the saturation magnetization at ~295 K ranging from ~0.08 emu/g to ~0.8 emu/g for samples with the lowest and higher BFO content, respectively.
In this paper, obsidian (OS) and bauxite (BX) are used to synthesize zeolites via KOH prefusion, followed by a conventional hydrothermal process (HY) or an unconventional vapor-phase crystallization method (VPC) at 90 °C. The results indicate that, due to their chemical and mineralogical composition, both natural sources prove to be suitable raw materials for potassium zeolite synthesis. However, the higher silica content in obsidian is decisive for the formation of merlinoite (MER topology) and, subordinately, merlinoite-chabazite intergrowths (MER-CHA), whereas the higher alumina content in bauxite controls chabazite (CHA topology) synthesis. Moreover, our hypothesis is that the lower water content in the VPC method enhances the Al concentration during the dissolution of pre-fused raw materials, thus favouring the formation of zeolite N (EDI topology) in BX, the raw material with the highest Al content. The synthetic products were further investigated for their magnetic properties and potential application in ammonium removal from polluted water. The predominant magnetic phases (i.e., ferrimagnetic or antiferromagnetic) demonstrate that the magnetic properties are mainly governed by the transformation pathways of iron-bearing phases, which are controlled by water availability during synthesis. In turn, this gives the possibility of tailoring both structural and magnetic order through careful selection of the raw material and synthesis conditions, while simultaneously enabling efficient ammonium removal from contaminated water.