A microwave photonic frequency multiplier with low phase noise based on an optoelectronic oscillator (OEO) is proposed and experimentally demonstrated. In this scheme, a dual-parallel Mach–Zehnder modulator (DPMZM) is employed to generate the third-harmonic frequency of the input radio frequency (RF) signal, while the oscillation frequency of the OEO is also three times the RF signal frequency. By adjusting the bias voltages of different arms in the DPMZM, a triple-frequency signal with a high side-mode suppression ratio of 64.8 dB can be obtained. The experimental results indicate that the output of the frequency-multiplier has a better single-sideband phase noise value, for instance, −126 dBc/Hz@10 kHz at 20.019 GHz. It has improvements of 34 dB and 43.5 dB compared with the input RF signal and the simulated electrical frequency tripler module, respectively.

A stable microwave signal transmission system for a distributed system that is capable of simultaneous downloads at multiple arbitrary nodes within the optical path is proposed. The download module, which is based on optical circulators and optical couplers, can be inserted at any node position within the transmission optical path to complete the downloading of frequency-synchronization signals. Experimentally, a distributed frequency-synchronization system with multiple download nodes is demonstrated over 40 km of optical fiber. Experimental results show that the signal has been downlink-transferred from different download modules with the standard deviation of phase jitter being 1°@10 GHz at 1 h through 40-km optical fiber. Moreover, the standard deviation of phase jitter between downloaded signals from any two download modules is also better than 1°@10 GHz at 1 h. In addition, the Allan Deviation is better than ${10}^{-12}$@1 h for the download module.

Low-finesse Fabry–Perot (F–P) cavities, widely applied in the field of micro-displacement measurement, offer significant advantages in reducing the influence of higher-order reflections and improving the accuracy of measurement systems. Generally, an F–P cavity finesse of 0.5 is required to achieve high-precision micro-displacement measurements. However, in optical design, low-finesse cavities impose strict requirements on reflectivity, and maintaining fine stability during cavity movement is challenging. Achieving ideal orthogonal interference with a finesse of 0.5 thus presents considerable difficulties. This study proposes a novel low-finesse F–P cavity design that employs a high-reflectivity spherical reflector and the end face of a fiber collimator as the reflective surfaces of the cavity. By utilizing beam divergence characteristics and geometric parameters, a structure with a finesse of approximately 0.5 is quantitatively designed, enabling a simplified implementation without the need for angular alignment. Compared with conventional approaches, this method eliminates the need for precise angular alignment of the reflective surfaces, significantly simplifying implementation. The experimental results show that, under fixed receiving field angles and beam radii of the fiber collimators, ideal orthogonal interference can be achieved by selecting the radius of the reflective sphere. Under varying working distances, the average finesse values of the interference spectra measured by Collimators 1 and 2 are 0.496 and 0.502, respectively, both close to the theoretical design value of 0.5, thereby meeting the design requirements.