Pressurized sand media filters are commonly used in drip irrigation systems to prevent emitter clogging. However, the performance of these filters may be improved with more information about the retention of solids at different bed depths under different filter operation conditions and irrigation water sources. In this study, experiments in a scaled sand media filter were conducted to clog the filter with two different filtration velocities (30 and 60 m h−1) and two-particle types (inorganic from A4 coarse sand dust and organic from a reclaimed effluent). The suspended solids retained in slices of 5 mm (in the first 20 mm of the bed) and 20 mm (from 20 to 200 mm depth) thick were determined following the van Staden and Haarhoff (2011) procedure. The solids retained in each slice per mass of media were significantly (p < 0.05) affected by the interaction between the filtration velocity, the bed depth, and the particle type. The solids retained in the first 5 mm of the bed were significantly higher than at other depths. Moreover, inorganic solids were retained more in upper slices than organic ones. Therefore, media depths may be adjusted depending on the irrigation water source to optimize media use.
Sand media filters are especially recommended to prevent emitter clogging with loaded irrigation waters, but their performances rely on backwashing. Despite backwashing being a basic procedure needed to restore the initial filtration capacity, there is a lack of information about the solid removal efficiency along the media bed depth. An experimental filter with a 200 mm silica sand bed height was used to assess the effect of two operation velocities (30/45 and 60/75 (filtration/backwashing) m h−1) and two clogging particles (inorganic sand dust and organic from a reclaimed effluent) on the efficiency of backwashing for removing the total suspended solids retained in different media bed slices. The average solid removal backwashing efficiency was greater with organic particles (78%) than with inorganic ones (64%), reaching its maximum at a 5–15 mm bed depth. A higher operation velocity increased the solid removal efficiency by 16%, using organic particles, but no significant differences were observed with inorganic particles. The removal efficiencies across the media bed were more uniform with organic particles (63–89%) than with inorganic (40–85%), which makes it not advisable to reduce the media height when reclaimed effluents are used. This study may contribute to future improvements in sand media filter design and management.
Making effective decisions about scaling up on-farm irrigation practices to the district level requires a comprehensive assessment of irrigation management at the farm level. In this context, a bucket-type water mass balance model was developed, calibrated, and validated over five irrigation seasons on a 121-hectare rice farm located in the lower Ter River valley (north-east Spain), to assess the water use efficiency and the impact of different irrigation practices on water savings. The model was implemented considering the spatial variability of the soils within the farm. It showed a satisfactory performance in both the calibration (2020, 2021, 2022) and validation (2023, 2024) cropping seasons, with NSE values greater than 0.50, PBIAS lower than ±20%, and RSR lower than 0.70. After model validation, the simulation of alternative water management practices revealed that the 10-day fixed-turn irrigation reduced irrigation water use by 30% compared to the traditional water management, although it may negatively impact rice yield. Simulations of an early irrigation cut-off at the end of the season and dry seeding with delayed flooding accounted for 17% and 15% irrigation water savings, respectively. The implementation of the no-runoff practice only accounted for a 6% reduction in water use. The water-saving potential of the simulated strategies was mainly driven by shortening the flooded period of rice paddies, thus demonstrating that managing the ponding water level is critical to diminishing water use in rice irrigation.