The investment estimation of the helium extraction project from natural gas is a crucial step in economically obtaining helium from both domestic and international projects. This article employs Aspen HYSYS to simulate the process and estimate the investment levels of Linde and Exxon Mobil integrated helium extraction processes. We investigate the influence of feed composition and processing capacity on investment costs and product returns. The results indicate that higher helium content of feed correlates with increased equipment investment costs and total capital cost (CAPEX), and that the Linde integrated process is significantly more sensitive to changes in helium content of feed than the Exxon Mobil integrated process. As the helium content of feed rises, the product returns of the two processes are evidently improved, leading to reduced investment payback periods. Both techniques exhibit favorable payback periods when the feed helium content exceeds 0.5 vol%. Nevertheless, elevated nitrogen content in the feed notably escalates the equipment investment costs and total capital costs. Furthermore, an increase in the processing capacity of feed gas leads to a nonlinear increase in total capital costs and annual operating costs. However, the cost per unit of helium extraction diminishes with increasing capacity. In general, the Linde integrated process requires higher separation energy consumption in comparison with the Exxon Mobil integrated process at similar processing capacities. Moreover, the sensitivity analysis shows that helium breakeven price is strongly affected by the price of both LNG and feed gas.

After long-term water injection development in Block M of the Gudong Oilfield, the fluid seepage field in the formation has become increasingly complex, and the heterogeneity of the reservoir has intensified. The uneven injection-production and the differences in lithological permeability have further led to a series of problems such as uneven reserve utilization, a low injection-production correspondence rate, and a poor overall development effect. During the development process, severe water flooding at the bottom and rich remaining oil at the top within the layer also emerged. These issues not only affected the economic benefits of the oilfield but also put forward higher requirements for the subsequent development strategies. In order to solve the above problems, based on a detailed analysis of geological characteristics, reservoir engineering and monitoring data, this paper uses the numerical simulation method to systematically simulate the dynamic changes in the residual oil saturation and pressure field in the formation under different development stages. The simulation results show that the pressure and saturation in each layer are both on a downward trend, especially in the layers with large pressure changes, where the oil saturation changes are more significant. Therefore, combined with the results of numerical simulation, a series of profile control and water shutoff schemes were systematically designed. These schemes covered different types of profile control agents and technological parameters. Representative well groups were selected to predict and evaluate the profile control effect. In the technical and economic evaluation of the profile control effect, the input–output ratio method was adopted. Finally, an optimal scheme was selected and applied in the field. The results show that after the implementation of this scheme, the daily oil increment of the well group was remarkable. During the test period, the cumulative oil increment reached 100 t, and the total expected oil increment could reach 190 t. The input–output ratio reached 1:2.1. The profile control measures significantly improved the injection-production correspondence, slowed down the in-layer water flooding, and further enhanced the recovery rate of remaining oil. In conclusion, the methods and achievements of this study can provide important technical references and support for the efficient and long-term development of similar high-water-cut and heterogeneous complex oil reservoirs, and have guiding significance for the subsequent adjustment, potential tapping, stable production and efficiency improvement of oilfields.