In an ever expanding railway network all around the world, the need for track maintenance grows steadily. Traditionally, one major part of track maintenance is ramming large vibrating steel picks into the gravel between and under railway sleepers to compress the gravel and generate a safe substructure. Even today, maintenance personnel still have to manually locate the sleepers if they cannot be detected by computer vision systems or visually by the operator. Here we developed a first of its kind magnetic sleeper detector, even able to find sleepers, buried in gravel, undetectable by vision based systems. Our approach of magnetic detection is based on a DC magnetic field excitation and a detector moving with respect to the rail system, including the sleepers and fasteners for mounting the rails. Due to railway application constraints a large air gap between the sensor and the sleeper structure is required, which significantly complicates the magnetic sensing task for robust sleeper detection. The design and optimization of the magnetic circuit was based on extensive 3D simulation studies to ensure highest possible variation in magnetic flux density at the sensor locations for absence and presence of a sleeper. Furthermore, a low noise and high sensitivity electronic circuit has been realized to cope with sensor signal offsets from unknown or changing sensor orientations with respect to the earth’s magnetic field, or magnetic interferences from other trains potentially passing by during active measurements. Since we only want to detect sleepers in close vicinity of the moving sensor system, digital signal processing of the acquired signals can easily compensate for disturbing slowly changing or static field components within real world application scenarios. We demonstrate that magnetic detection of even buried sleepers on railway tracks is possible for distances of up to 172 mm between the sensor and the sleeper. This enables an even higher level of railway maintenance automation previously impossible in certain scenarios.
Detecting only minute amounts of ferromagnetic materials introduced into a large air gap magnetic circuit can be quite challenging since the coupling is only rather loose and is aggravated by the fact that the ferromagnetic part of the circuit is a good electrical conductor, too. We report on the design of a sensor that allows the detection of railroad sleepers via their sleeper bolts, which in all cases are made of ferromagnetic material regardless of the wide range of sleeper materials. Since there is a strictly regulated railroad clearance profile, the air gap of the magnetic circuit is relatively large, which the sensor design must take into account. The sensor must also accommodate external interfering static and dynamic magnetic fields caused by strong DC and AC currents flowing nearby. Focus is put on standard bolts separated from the sensor by air gaps of up to 150 mm. The sensor system has to cope with and include in its design the ferromagnetic rail over which the sensor is guided with mostly undisclosed properties but still needs to guarantee a close to optimal detection probability of various ferromagnetic parts of also undisclosed properties, except them being ferromagnetic. We report on the design process that ultimately led to a high performance sensor system. In the design process we had to resort to series of 3D magnetic field simulations where we chose to vary in steps those geometric parameters that are left open to the designer and the type and size of a permanent magnet used to excite the magnetic circuit. It turned out that Hall-effect transducers are ideally suited to register field variations caused by the motion of the to be detected object. The interference suppression is done by processing, using among others a dynamic time warping scheme, the output signals of several Hall elements arranged in a line-scan camera like setup. First results are presented.