Additive Manufacturing (AM) enables the automated production of complex geometries with low waste and lead time, notably through Material Extrusion (MEX). This study explores Large Format Additive Manufacturing (LFAM) with carbon fiber-reinforced polyaryletherketones (PAEK), particularly a slow crystallizing grade by Victrex. The research investigates how extrusion parameters affect the mechanical properties of the printed parts. Key parameters include line width, layer height, layer time, and extrusion temperature, analyzed through a series of controlled experiments. Thermal history during printing, including cooling rates and substrate temperatures, was monitored using thermocouples and infrared cameras. The crystallization behavior of PAEK was replicated in a Differential Scanning Calorimetry (DSC) setup. Mechanical properties were evaluated using three-point bending tests to analyze the impact of thermal conditions at the deposition interface on interlayer bonding and overall part strength. The study suggests aggregated metrics, enthalpy deposition rate and shear rate under the nozzle, that should be maximized to enhance mechanical performance. The findings show that the common practice of setting fixed layer times falls short of ensuring repeatable part quality.
18 July 2024 in Journal of Thermoplastic Composite Materials
In this work, we investigated the effect of plain woven carbon fiber tape embedded in each layer of an additively manufactured part on the coefficient of thermal expansion (CTE) and compared it to conventionally printed parts. Current advancements in Additive Manufacturing enable cost-efficient 3D printing of composite tools. However, these tools do not yet offer a low CTE comparable to Invar, necessary for producing aerospace-quality composite parts. Using the novel Advanced Tape Layer Additive Manufacturing process, the tape is placed on top of the bead immediately after extruding the short fiber-reinforced material. The samples are compared to Material Extrusion specimens from a Large Format Additive Manufacturing System. A lower CTE was achieved within the printing plane. Micro-computed tomography images correlate the preferential orientation of short fibers with measured CTE values. The CTE modification can match the part CTE to the tool CTE and therefore optimize the quality of manufactured parts.
This work presents a microstructure-informed pathway for assigning a material symmetry class to distinguish between tensor components and scalar effective thermal conductivity (ETC) values derived from directional measurements. The framework combines directional thermal measurements with three-dimensional statistical quantification of microstructural features (fibers and voids) to assess whether symmetry assumptions required for tensorial interpretation are justified. Three distinct microstructures of short carbon fiber-reinforced polyetherimide composite were analyzed, with the microstructure statistics altered by the melt extrusion additive manufacturing process parameters. The directional temperature-rise history in the material samples was measured using the Transient Plane Source sensor. The statistics obtained from 3D images of microstructural features were used to assess the material’s anisotropy class to justify the applicability of the transverse isotropic regression method for ETC. One microstructure exhibited characteristics consistent with a statistical transverse isotropy idealization, enabling inference of the ETC tensor; the others did not, and their directional ETC values are treated as test-specific parameters obtained from isotropic model fits. The results also demonstrate that microstructure parameters may strongly influence directional thermal transport. More broadly, this work highlights the need for microstructure-informed justification when interpreting directional measurements as tensor components rather than configuration-dependent scalars, underscoring a critical unresolved gap in the experimental characterization of general anisotropic ETC tensors.