Este trabajo busca analizar las vibraciones generadas por el paso de diferentes tipos de vehículos en entornos urbanos, con especial énfasis en el transporte público, debido a la tendencia de electrificación del parque móvil que se está produciendo actualmente.Para ello, se han evaluado las vibraciones producidas por el paso de autobuses, tanto térmicos como eléctricos, en las inmediaciones de las vías de diferentes localizaciones de la ciudad de Montevideo (Uruguay), con el objetivo de proteger de los efectos nocivos de las vibraciones a las viviendas cercanas. A su vez, se han realizado también medidas de vibraciones en la ciudad de Elche (España).Paralelamente, se ha desarrollado un modelo de elementos finitos que permite predecir la propagación de las vibraciones debidas a la circulación de vehículos. Este modelo se encuentra parametrizado para poder comparar los efectos vibracionales de diferentes categorías de vehículos, así como de diferentes tipologías de calzada.
The case study we present in this paper is related to the non-expected acoustic behavior of a set of large diesel engines. There were 8 reconverted 4-cycle Diesel engines of 10 MW of nominal power each, which generate alternating current at 50 Hz. Two years later than their installation, the engines needed another important modification to meet the NOx emission specifications. The cylinders’ chambers were modified and a turbocharger group operating at 25,500 rpm was installed in each engine. Sometime later, non-expected behaviors related to the acoustic emissions from the engines were perceived. Particularly, a “random variability” of sound pressure levels emitted by large engines operating in the same conditions with only a few hours of difference was recorded in many opportunities. When faced with this problem, there was a set of not obvious open questions. Finally, we met the answers to the most critical questions: the problem of noise was due to thermoacoustic instabilities, which is a phenomenon expected in large engines. The ideal approach to control this type of acoustic emission is the use of hybrid silencers, which function as passive silencers in high frequencies and include a solution of active noise control for low ones.
Aeroacoustic phenomena generated by wind–structure interaction have gained increasing relevance due to the widespread use of lightweight and permeable façade elements. Several studies have shown that such configurations may emit tonal noise, yet their prediction and mitigation remain challenging. To address this, a dedicated experimental facility was developed to study, under controlled conditions, the coupling between the flow field and the acoustic field.
Urban areas continue to grow steadily, leading to increases in vehicular traffic and urban noise levels, which may affect public health and quality of life. In this context, it is essential to develop tools capable of estimating and analyzing traffic-related noise. This work presents an update of the urban noise prediction model developed for Montevideo in 2000, incorporating new data obtained from the acoustic map of Montevideo 2024–2025 and recalibrating its parameters to current traffic conditions. To this end, variables such as traffic flow and composition, vehicle speed, and the presence of anomalous acoustic events (e.g., horns, braking, or modified exhaust systems) were analyzed. A statistical analysis of the recorded sound levels was also carried out to identify anomalous acoustic events and evaluate their influence on noise levels. Based on this analysis, correction factors related to these events and to traffic speed were incorporated into the model. The results show that the updated model improves predictive performance compared with the original formulation, reducing the percentage of errors outside the ±3 dBA range. Overall, the model constitutes a useful tool for estimating urban noise in Montevideo during daytime hours for traffic densities between 200 and 3000 veh/h, although challenges remain due to the high variability of the acoustic environment.
This work aims to analyze the occurrence of anomalous acoustic emissions that appeared after the modification of the combustion chambers of eight reconverted four-stroke diesel engines (10 MW each, urban installation). Large variability of the sound pressure levels emitted by the same engine under nominally identical operating conditions was recorded. The phenomenon was interpreted at first as thermoacoustic instability developing inside the combustion chambers, supported by the simultaneous observation of large fluctuations in the fuel inlet pressure. Four precursor episodes were documented through an operational signature qualitatively consistent with the loss-of-chaos pattern reported in the literature. However, most of these events anticipated a decrease in the sound pressure levels in the considered third-octave band, the opposite of what is expected to happen in thermoacoustic instability events. The 0–1 test for loss-of-chaos was applied, ratifying the occurrence of a long precursor condition that should anticipate the installation of a thermoacoustic instability. The shortest timescale of the precursor states was 500 s, in contrast with the millisecond- to second-range timescales typically reported in laboratory-scale studies. Although the sample is limited, the observations suggest that long precursors may occur in megawatt-scale installations, anticipating different types of sudden changes in the operational conditions (not only thermoacoustic instability). If confirmed, it would open a practical window for feedforward active noise control to avoid abrupt changes in the engine operating conditions. A hybrid silencing strategy is proposed as a design recommendation. Limitations and the current operational status of the installation are also discussed.
En el trabajo de tesis Doctoral en Ingeniería Ambiental titulado “Protocolo para análisis de fenómenos Aeroacústicos” se recopilaron casos de fenómenos aeroacústicos generados entre la interacción del viento con elementos estructurales en fachadas de edificios o elementos de estructuras, como, por ejemplo, barandillas en puentes. Se vio que el fenómeno aeroacústico está presente, pero no han sido muchos los autores e investigadores que han desarrollado e incursionado en este tema. En este documento se presentarán algunos de los casos identificados en los últimos años, demostrando que es un fenómeno aeroacústico contemporáneo, el cual se reitera debido a los nuevos diseños y materiales constructivos utilizados por la arquitectura moderna. Además, se presentará una recopilación fotográfica realizada en Uruguayde las ultimas construcciones con potencial a desarrollar la ocurrencia de dicho fenómeno.