Yelena Iozasovna Malashkevichute-Brillant

Mrs. Yelena Iozasovna Malashkevichute-Brillant


Research Focus & Metrics

Academic Career Length

3Years (2024-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
30 September 2024 in Acta Metallurgica Slovaca
Verified
Journal Article
Open access
PDF file
VAViolleta Alexandrovna Andreyaschenko
Violleta Alexandrovna Andreyaschenko
IBIgor Bartenev
Igor Bartenev
YMYelena Iozasovna Malashkevichute-Brillant
Yelena Iozasovna Malashkevichute-Brillant
Developing lightweight, high-strength materials is an important technological problem of the present decade. However, alloying with expensive elements is mainly used to increase the strength of structural materials. In contrast, aluminum alloys with a specific ratio of silicon and iron show very high mechanical properties. This work aims to develop a technology for synthesizing an aluminium-based alloy with a high content of iron and silicon, consisting mainly of intermetallic phases and having high strength and hardness. The additive technology method of surfacing with a consumable electrode produced the alloy. The ratio of the initial components, meticulously determined, led to the precise chemical composition of the alloy. As a result of the synthesis, an ingot with a uniform microstructure and insignificant porosity, a testament to the careful process, was obtained. At room temperature, the alloy has a phase composition of 42.6% β-phase, 43.4% θ-phase and 13.5% FCC-phase. Phases β and θ are large particles between which the FCC aluminum phase is located. The hardness of the intermetallic β/θ is 450.8±5 HV1, FCC aluminum has a hardness of 92.5 HV1. This research has the potential to inspire further developments in materials science and engineering.

25 December 2024 in Preprints.org
Verified
Preprint
Open access
PDF file
TBToty Buzauova
Toty Buzauova
BSBaglan Smailova
Baglan Smailova
YMYelena Iozasovna Malashkevichute-Brillant
Yelena Iozasovna Malashkevichute-Brillant
OOOmirzhan Oktyabrov
Omirzhan Oktyabrov
Stresses in surfaced gear teeth, particularly at the interface between the base metal and the surfaced layer, have consistently drawn scientific interest. However, a review of the literature revealed that these questions remain unanswered. Until now, the stress-strain state of surfaced gear teeth has not been thoroughly investigated. In this regard, the issues addressed in this article are both relevant and of significant scientific interest. The paper focuses on the calculation of cylindrical gear transmissions using analytical and numerical methods to determine contact and bending stresses. The results of analytical calculations are compared with numerical modeling data obtained using the Ansys Workbench software environment. A comparative analysis of the results is conducted, and discrepancies between the calculations are identified. Special attention is given to the analysis of stresses in surfaced gear teeth compared to solid ones. Unlike standard calculations for solid gears, this study focuses on the stress-strain state of surfaced teeth, taking into account their operational properties. For a more detailed analysis, the concept of the 'tooth contact angle position' is introduced, which allowed for an in-depth investigation of its stress-strain state. The obtained results help identify the specific behavior of restored teeth under load, which is particularly relevant for developing gear transmission restoration technologies and assessing their durability. Considering the operational properties of surfaced teeth enables a more accurate evaluation of their strength characteristics. This study is aimed at assessing the strength properties of gear transmissions with surfaced teeth and can be used to optimize their design.