This paper presents a comprehensive analysis of a multi-door check valve using computational fluid dynamics (CFD) and finite element analysis (FEA) to evaluate flow performance under pressure test conditions, with an emphasis on its ability to prevent backflow. Check valves are essential components in various industries, ensuring fluid flow in one direction only while preventing reverse flow. The non-return multi-door reflux valve is increasingly preferred due to its superior backflow prevention, fluid control, and effective flow regulation. Rigorous testing under varying pressure conditions is essential to ensure that these valves perform optimally. This study uses CFD and FEA simulations to evaluate the structural integrity and flow characteristics of the valve, including pressure drop, flow velocity, backflow prevention effectiveness, and flow coefficient. A high-fidelity 3D model was created to simulate the valve’s behavior under various conditions, analyzing the effects of parameters such as the number of doors, their orientation, geometry, and operating conditions. The CFD results demonstrated a significant reduction in backflow and pressure drop across the valve. However, localized turbulence and flow separation near the valve doors, particularly under partially open conditions, have raised concerns about potential wear. The velocity profiles indicated a uniform distribution at full opening with laminar velocity profiles and minimal resistance to flow. The results of the FEA showed that the stresses induced by the fluid forces were below critical levels, with the highest stress concentrations observed around the hinge points of the valve doors. Although the valve structure remained intact under normal operating conditions, some areas may have required reinforcement to ensure long-term durability. Combined CFD and FEA analyses demonstrated that the valve effectively preserves system integrity, prevents backflow, and maintains consistent performance under various pressure and flow conditions. These findings provide valuable insights into design improvements, performance optimization, and enhancing the efficiency and reliability of reflux valve systems in industrial applications.
Non-return multi-door reflux valves are essential in fluid control systems to prevent reverse flow and maintain system integrity. This study experimentally analyzes the flow performance of multi-door check valves under different operating conditions, focusing on pressure testing and evaluating their effectiveness in preventing backflow. A wide-ranging experimental setup was designed and implemented to simulate real-world scenarios, facilitating accurate measurement of flow rates, pressure differences, and valve response times. The collected experimental data were analyzed to evaluate the valve’s performance in terms of flow capacity, pressure drop, and hydraulic efficiency. Additionally, the effects of factors such as valve size, valve configuration, and fluid properties (water) on performance were considered. It was found that the non-return multi-door reflux valve has been proven effective and reliable in preserving system integrity and maintaining unidirectional flow at the same time during pressure testing. It exhibits no backflow, remains stable and constant across varied flow conditions, and demonstrates a low pressure drop and high flow capacity, making it suitable for critical pressure testing applications. The response curve revealed that valve opening takes longer to reach higher flow rates than closing, indicating pressure instability during transition periods. This non-linear relationship indicates possible irregularities in pressure drop response to flow rate changes, highlighting potential areas for further investigation.