Bound states in the continuum (BICs) in open cavities have attracted considerable attention in wave physics due to their ability to confine light and produce high-quality-factor resonances with promising applications for filtering and sensing. One of the most interesting types of BICs is Friedrich-Wintgen (FW) BICs, which result from destructive interference of two interacting modes belonging to the same radiation channel. Here, we investigate theoretically and experimentally FW BICs in a photonic and plasmonic T-shaped cavity made of two horizontal guides of lengths and coupled to a vertical stub of length . We demonstrate that the necessary condition for obtaining BICs consists in taking the lengths of the two horizontal guides and commensurate. This BIC is a common mode of the guides of lengths and , such as the electric field vanishes at their connection point with the stub of length ; this BIC is independent of and the infinite waveguide to which the whole cavity will be attached. We show that, depending on , the FW BIC appears as the consequence of the interaction between two eigenmodes of the originally isolated cavity where the width of one mode vanishes giving rise to FW BIC, while the width of the second mode becomes broad. In addition, we show that by slightly deviating from the BIC condition, the latter transforms to either electromagnetically induced transparency (EIT) or reflection or Autler-Townes splitting (ATS) resonances. Both EIT and ATS effects are qualified as a transparency window between two transmission zeros, but with different physical origins. We exploit the Akaike’s information criterion test to discern EIT from ATS and distinguish the regime where the EIT or ATS effect dominates. The theoretical results, obtained by means of the Green’s function method, are validated both by experimental measurements using coaxial cables in the radiofrequency domain and numerical simulations using metal-insulator-metal plasmonic waveguides operating in the infrared domain. The sensitivity of the PIT (the plasmonic analogue of EIT) resonances to the dielectric inside the waveguides can be used to design a highly sensitive sensor, which makes it suitable for an on-chip optical sensing platform.
Bound states in the continuum (BICs) are zero-width (infinite lifetime) trapped eigenmodes that remain confined in the system even though they coexist with a continuum of extended states. The resulting high-frequency resonances may have significant applications in photonic integrated circuits, filtering, sensing, and laser. In this paper, we demonstrate that a simple design based on a photonic triple-stub cavity can display both Fabry-Pérot (FP) and Friedrich-Wintgen (FW) BICs, and their occurrence is very dependent on the way the cavity is attached to the outside medium by one or two ports. We first consider a symmetric cavity where a stub of length is surrounded by two stubs of length , and all stubs are separated by segments of length . When the cavity is inserted between two ports, we demonstrate theoretically and validate experimentally the existence of symmetric BICs (S-BIC) and antisymmetric BICs (AS-BIC) of FP type under commensurability conditions between the lengths , and . The S-BICs and AS-BICs may cross each other, giving rise to a doubly degenerate BIC. By breaking the symmetry of the cavity, AS-BICs and S-BICs can couple together and realize a FW-type BIC where one resonance remains with zero width while the other broadens into a bright mode. By considering two additional configurations where the triple-stub cavity is attached with one or two ports from only one side, additional BICs can be induced inside the structure. By slightly detuning from the BIC condition, the latter transforms into either an electromagnetic-induced transparency/reflection or Fano resonance. Finally, such a triple-stub cavity can be designed to realize near-perfect absorption for some frequencies. All the analytical results, obtained from the Green's function method, have been confirmed experimentally in the radiofrequency domain using coaxial cables.
We provide theoretical and experimental evidence for the existence of topological Tamm states at the interface between two stubbed photonic crystals (PCs) as a function of the period and length of the stubs. Several works have addressed these states in the well-known Su-Schrieffer-Heeger model, a dimerized chain based on two resonators per unit cell where the opening of a gap at a Dirac cone results in a symmetry inversion of bulk bands between two topologically different crystals. Here, we give a detailed theoretical analysis of a mechanism based on band-edge symmetry inversion around a flat band, i.e., when the width of the pass band vanishes, while using only one resonator (stub) per unit cell. Then, we propose a simple versatile experimental platform to observe such interface states, which is based on coaxial cables operating in the radio-frequency domain. The investigation of these states was performed by using different approaches: (i) the topology of the bands based on the Zak phase and the symmetry of the band-edge modes, (ii) the sign of the reflection phase between each PC and a waveguide, and (iii) the dips or peaks in the reflection and transmission spectra when two finite photonic crystals are connected together either horizontally or vertically along a waveguide. Furthermore, we give a general rule about the existence of interface states when two PCs exhibit two common gaps with a flat band in their middle and different bulk-edge symmetries. Also, we provide closed-form expressions of the geometrical parameters and the frequency for which the interface state becomes bound state in the continuum (BIC). We show that these topological BIC states are stationary states of the cavity between the two PCs, and are very robust to any perturbation on both sides of the cavity. Finally, we show the impossibility of existence of interface states between two PCs with identical periods and different stubs. The theoretical and experimental results are discussed for both Neumann and Dirichlet boundary conditions at the end of the stubs.
We demonstrate a novel approach to inversely design one-dimensional (1D) photonic stubbed systems with targeted topological properties by leveraging the po
We investigate the existence of acoustic Tamm states at the interface between two one-dimensional (1D) comblike phononic crystals (PnCs) based on slender tubes and discuss their topological or trivial character. The PnCs consist of stubs grafted periodically along a waveguide and the two crystals differ by their geometrical parameters (period and length of the stubs). We use several approaches to discuss the existence of Tamm states and their topology when connecting two half-crystals. First, we derive a necessary and sufficient condition on the existence of interface states based on the analysis of the bulk band structure and the symmetry of the band edge states. This approach is equivalent to an analysis of the Zak phases of the bulk bands in the two crystals. Indeed, a topological interface state should necessarily exist in any common bandgap of the two PnCs for which the lower (upper) band edges have opposite symmetries. A novelty of our structure consists in the fact that the symmetry inversion results from a band closure (flat band) rather than from a gap closure, in contrast to previous works. Then, such interface states are revealed through different physical quantities, namely: (i) the local density of states (LDOS), which exhibits a high localization around the interface; (ii) sharp peaks in the transmission spectra in the common bandgap when two finite crystals are connected together; (iii) the phases of the reflection coefficients at the boundary of each PnC with a waveguide, which have a direct relationship with the Zak phases. In addition, we show that the interface states can transform to bound states in the continuum (BICs). These BICs are induced by the cavity separating both PnCs and they remain robust to any geometrical disorder induced by the stubs and segments around this cavity. Finally, we show the impossibility of interface states between two connected PnCs with different stub lengths and similar periods. The sensitivity of these states to interface perturbations can find many practical applications in PnC sensors.
The study of localized surface plasmons (LSPs) in nanoscale structures is an essential step towards identifying optimal plasmonic modes that can facilitate robust optomechanical coupling and deepen our understanding of light–matter interactions at the nanoscale. This paper investigates, numerically, using the finite element method, LSP modes in a design comprising two coupled nano-ridges deposited on a gold layer with an interposing polymer spacer layer. Such a structure, usually referred to as a particle-on-mirror structure, shows exquisite optical properties at the nanoscale. We first examine the LSP modes of a single nano-ridge through the analysis of its scattering cross-section in the visible and infrared ranges. To enhance the plasmonic response, a thin polymer layer is placed at the middle of the ridge, which introduces additional LSP modes confined within the former. Then, we extend the analysis to the dimer configuration, which exhibits more complex and enhanced plasmonic behavior compared to a single nano-ridge. In particular, the dimer configuration yields LSP resonances with a quality factor enhancement of approximately threefold relative to a single nano-ridge. Furthermore, the presence of the polymer layer within the ridges significantly improves plasmon field localization and the quality factor. These findings underscore the potential of nano-ridge-based structures in advancing optomechanical coupling and offering valuable insights for the development of high-performance acousto-plasmonic devices. In particular, the proposed device could help significantly improve the design of nano-acousto-optic modulators, operating in the visible or in the near-infrared ranges, that require an enhanced light–phonon coupling rate.