Water well pressure-driven reconstruction can replenish reservoir energy in a short time, significantly enhancing water injection capacity, forming effective displacement pressure differentials, and increasing oil well liquid production capacity. It is an effective means to resolve contradictions in developing low-permeability reservoirs. Addressing the complex fracture zones formed during pressure-driven processes involves conducting pressure-driven core experiments to ascertain the law of effective stress and permeability changes in target reservoirs, and establishing constitutive equations for dynamic permeability changes. The fitting coefficient of the equation to the experimental data reaches 0.99. The main fractures formed during the pressure drive control the direction of the modified zone. The simulation results show that the length of the main fractures ranges from 32 to 256 m, and a microfracture zone of 0 to 50 m is formed along the sides of the main fractures. Compared to conventional water injection pressure drives, the injection capacity is enhanced by 4 to 8 times. simulations show that employing dynamic permeability equations for pressure-driven reconstruction zones achieves good fitting of bottom-hole pressures under high injection conditions.

At present, many offshore oil fields are facing problems, such as pollution-induced near-well zone blockage, poor inter-well connectivity, and strong vertical heterogeneity, which lead to insufficient formation energy and low production in the middle and late stages of development. It is necessary to develop a new technology to overcome these issues. In this regard, water-injection-induced dilation technology, which was already proven to have positive effects on loose sandstone reservoirs, was controversially applied to an offshore low-permeability reservoir. To investigate whether the water-injection-induced dilation technology is suitable, experiments were conducted to analyze the dilation potential of offshore low-permeability sandstone reservoirs, namely, X-ray diffraction, laser particle size analysis, physical simulation, computed tomography scan, and electron microscope scanning experiments. The X-ray diffraction experiments showed that the samples had more than 80% non-clay mineral content and a high brittleness index, which meant more complex microfractures under water injection. Particle size analysis experiments revealed that the particle size was mainly between 10 μm and 100 μm, and thus belonged to coarse silty sand. According to the sorting grade, the sample particle size distribution was uniform and the reservoir was more prone to dilation. The true triaxial physical simulation showed that a volumetric dilation zone occurred around the wellbore, where complicated microfractures occurred. This paper provides adequate evidence and mechanisms of dilation potential for an offshore low-permeability sandstone reservoir.

With the development of offshore oil fields, the reservoirs of X oilfield in the west of the South China Sea are poor in physical property, serious in pollution, and increasingly prominent in interlayer contradictions. Water injection dilation technology has strongly affected the development of loose sandstone reservoirs. To explore whether this technology applies to the low-permeability sandstone of X oilfield in the west of the South China Sea and the dilation effect and radius of water injection dilation technology on the target reservoir, low confining pressure rock mechanics experiments and numerical simulation of water injection in this reservoir section are carried out. The triaxial shear experiment of low confining pressure shows that the target reservoir sandstone with low-permeability can have a shear strength of 45 MPa when the effective confining pressure is 0.5 MPa, and the target reservoir core can have dilatancy. When the axial strain is 2.5%, the core dilatancy is 1%, and the permeability changes by 1.17 times. It was found that the core volume dilation was obviously under low effective confining pressure, and the permeability is 2 orders higher than in the initial condition. The numerical simulation of the target reservoir shows that the bottom-hole pressure reaches 47.12 MPa at the end of water injection in typical wells. The reservoir was deformed to different degrees around the well, and the top layer was raised by 5.58 mm. This paper characterizes the rock expansion potential and expansion flow capacity of low-permeability sandstone reservoirs from multiple perspectives and establishes a three-dimensional, full-size wellbore formation crustal stress strict matching geological model for offshore expansion wells. We have provided theoretical guidance for on-site construction.