Fuel wood pellets have the tendency of undergoing self-heating and off-gassing during storage and transportation. Self-heating can lead to spontaneous combustion and cause fires while toxic gasses such as carbon monoxide and some volatile organic compounds released due to off-gassing are a human health and environmental hazard. Previous research suggests that the self-heating and off-gassing of wood pellets are as a result of the oxidation of wood extractives. The aim of this study was to identify the extractives, i.e., fatty and resin acids that are responsible for the emissions of carbon monoxide, carbon dioxide and methane from wood pellets by testing the off-gassing tendencies of pellets produced from synthetic microcrystalline cellulose and different additive oils. The additive oils were intentionally selected to represent different types of wood extractives (mainly fatty and resin acids) and they included: tall oil, pine rosin, linseed oil and coconut oil. The highest mean concentrations of carbon monoxide, carbon dioxide and methane were recorded from cellulose pellets with added linseed oil. The concentrations of carbon monoxide and methane for the other four pellet types were negligible and there was no carbon dioxide emission. Pellets with added linseed oil had high off-gas emissions due to the high content of unsaturated fatty acids compared to other pellet types.
In order to evaluate the effect of extractives on particle bonding, pellets were produced from extracted and nonextracted Scots pine sawdust in a laboratory piston press pelletizer. In the experiment, the raw material and process parameters were fresh (nonextracted) and acetone-extracted sawdust, sawdust moisture content (6% and 12%), piston pressure (70 and 150 MPa), and press temperature (100°C and 180°C). The resulting pellets were evaluated and compared for density, compression strength, and moisture sorption. The relationship between factors and responses was evaluated by partial least squares regression. In the present study, it was found that pressure and temperature had a positive effect on both pellet density and compression strength. Extracted sawdust gave pellets with a higher density and compression strength than pellets made from nonextracted sawdust. Moisture sorption between the produced pellets showed no significant differences. Results of this study provide a plausible explanation for why pellets produced from stored sawdust with low amounts of extractives have better strength properties than pellets produced from fresh sawdust.
Wood pellets produced from fresh sawdust can form and release uncontrolled gases during bulk storage, a tendency referred to as off-gassing. This study investigated the off-gassing tendencies of Scots pine wood pellets made from separated sapwood and heartwood sawdust. The effects of drying temperature, raw material storage, as well as varying proportions of sapwood and heartwood were also investigated. There was a strong linear correlation between off-gassing and sapwood content, with correlation coefficient (R) values greater than 0.9 at p < 0.001 for all the off-gases. An increase in sapwood content of the feedstock led to a significant increase in off-gassing of CO2, CO, and CH4, and O2 consumption. The drying temperature of the raw material had a significant effect on off-gassing of both sapwood (F(8, 26) = 51.32, p < 0.05) and heartwood (F(8, 26) = 334.1, p < 0.05) pellets. Increasing the drying temperature for heartwood resulted in increased off-gassing, while for sapwood, the off-gassing reduced. Storage of sapwood raw material before pelletization reduced the off-gassing of wood pellets, whereas for heartwood, it had no significant impact. Based on the results, it is suggested that a biological process, in combination with the chemical oxidation of fatty acids, lay behind the off-gassing of wood pellets.
3 March 2026 in Journal of Agriculture and Food Research