We report the fabrication and optical characterization of Yb3+-doped waveguide amplifiers (YDWA) on the thin film lithium niobate fabricated by photolithography assisted chemo-mechanical etching. The fabricated Yb3+-doped lithium niobate waveguides demonstrates low propagation loss of 0.13 dB/cm at 1030 nm and 0.1 dB/cm at 1060 nm. The internal net gain of 5 dB at 1030 nm and 8 dB at 1060 nm are measured on a 4.0 cm long waveguide pumped by 976 nm laser diodes, indicating the gain per unit length of 1.25 dB/cm at 1030 nm and 2 dB/cm at 1060 nm, respectively. The integrated Yb3+-doped lithium niobate waveguide amplifiers will benefit the development of a powerful gain platform and are expected to contribute to the high-density integration of thin film lithium niobate based photonic chip.
We demonstrate a narrow linewidth 980 nm laser by self-injection locking of an electrically pumped distributed-feedback (DFB) laser diode to a high quality (Q) factor (>105) lithium niobate (LN) microring resonator. The lithium niobate microring resonator is fabricated by photolithography-assisted chemo-mechanical etching (PLACE) technique, and the Q factor of lithium niobate microring is measured as high as 6.91 × 105. The linewidth of the multimode 980 nm laser diode, which is ~2 nm measured from its output end, is narrowed down to 35 pm with a single-mode characteristic after coupling with the high-Q LN microring resonator. The output power of the narrow-linewidth microlaser is about 4.27 mW, and the wavelength tuning range reaches 2.57 nm. This work explores a hybrid integrated narrow linewidth 980 nm laser that has potential applications in high-efficient pump laser, optical tweezers, quantum information, as well as chip-based precision spectroscopy and metrology.
We demonstrate high-extraction-rate Ta2O5-core/SiO2-clad photonic waveguides on silicon fabricated by the photolithography-assisted chemo-mechanical etching technique. Low-confinement waveguides of larger than 70% coupling efficiency with optical fibers and medium propagation loss around 1 dB/cm are investigated in the experiment. Monolithic microring resonators based on Ta2O5 waveguides have shown the quality factors to be above 105 near 1550 nm. The demonstrated Ta2O5 waveguides and their fabrication method hold great promise in various cost-effective applications, such as optical interconnecting and switching.
In this paper, multifunctional, multilevel phase plates of quartz substrate were efficiently prepared by using a newly developed polygon scanner-based femtosecond laser photolithography system combined with inductively coupled discharge plasma reactive-ion etching (ICP-RIE) technology. The femtosecond laser photolithography system can achieve a scanning speed of 5 m/s and a preparation efficiency of 15 cm2/h while ensuring an overlay alignment accuracy of less than 100 nm and a writing resolution of 500 nm. The ICP-RIE technology can control the etching depth error within ±5 nm and the mask-to-mask edge error is less than 1 μm. An 8-level Fresnel lens phase plate with a focal length of 20 mm and an 8-level Fresnel axicon phase plate with a cone angle of 5° were demonstrated. The diffraction efficiency was greater than 93%, and their performance was tested for focusing and glass cutting, respectively. Combined with the high-speed femtosecond laser photolithography system’s infinite field-of-view (IFOV) processing capability, the one-time direct writing preparation of phase plate masks of different sizes was realized on a 6-inch wafer. This is expected to reduce the production cost of quartz substrate diffractive optical elements and promote their customized mass production.