This paper presents a recent investigation into the electromechanical behavior of thermally reduced graphene oxide (rGO) as a strain sensor undergoing repeated large mechanical strains up to 20.72%, with electrical signal output measurement in multiple directions relative to the applied strain. Strain is one the most basic and most common stimuli sensed. rGO can be synthesized from abundant materials, can survive exposure to large strains (up to 20.72%), can be synthesized directly on structures with relative ease, and provides high sensitivity, with gauge factors up to 200 regularly reported. In this investigation, a suspension of graphene oxide flakes was deposited onto Polydimethylsiloxane (PDMS) substrates and thermally reduced to create macroscopic rGO-strain sensors. Electrical resistance parallel to the direction of applied tension () demonstrated linear behavior (similar to the piezoresistive behavior of solid materials under strain) up to strains around 7.5%, beyond which nonlinear resistive behavior (similar to percolative electrical behavior) was observed. Cyclic tensile testing results suggested that some residual micro-cracks remained in place after relaxation from the first cycle of tensile loading. A linear fit across the range of strains investigated produced a gauge factor of 91.50(Ω/Ω)/(m/m), though it was observed that the behavior at high strains was clearly nonlinear. Hysteresis testing showed high consistency in the electromechanical response of the sensor between loading and unloading within cycles as well as increased consistency in the pattern of the response between different cycles starting from cycle 2.
This paper presents a recent investigation into sensing and measurement of large strain (>10%) based on variation in electrical resistance of reduced graphene oxide. Sensing and measurement of large strain is of great interest for highly flexible and stretchable systems with applications including monitoring human motion, soft robotics and structural health monitoring. Measuring large strains is challenging because many traditional engineering materials yield or fracture at relatively small strains. Nanoparticle-based strain gauges have been investigated and regularly found to survive strains up to 50% with sensitivity (gauge factor) near 100 times greater than conventional metal foil strain gauges. However, most of these nanoparticle-based strain gauges have been made of toxic materials and are expensive to create (e.g. nickel or silver nanoparticles). Recent research has uncovered incredible properties of graphene which can overcome these issues, composed of inexpensive and natural carbon and surviving strain up to 20%. Direct synthesis and deposition of graphene monolayers remains expensive and complex. Reduced graphene oxide shares many of the phenomenal properties of graphene but can be synthesized with simple drop casting and thermal reduction techniques. This paper presents recent research into measurement of strains greater than 10% by monitoring the change in resistance of reduced graphene oxide patches. A combination of electrical, mechanical, and microscopic investigations were performed to understand the electromechanical behavior of the material. A highly linear relation between resistance and strain was observed at relatively small strains, consistent with piezoresistive theory from monolithic materials, while a nonlinear relation was observed at strains from 12% to 20%, consistent with percolative behavior of nanoparticle-based strain sensors. The relation between non-aligned strain and resistance measurement was also investigated (e.g. perpendicular and off axis). Continuing investigation is seeking to understand the origins of the electrical and mechanical behavior observed.