Brookite is the least investigated phase of TiO2 due to the synthetic difficulty of obtaining the pure phase. Here, we present the first ever chemical vapor deposition synthesis of pure brookite TiO2 thin films. The films were highly crystalline and phase pure as determined by X-ray diffraction and Raman spectroscopy studies. Scanning electron microscopy studies showed the films to have a structured morphology consisting of pyramidal features. The photocatalytic properties of the brookite film, tested using stearic acid under UVA (365 nm) irradiation, were superior to both an anatase film grown under similar conditions and NSG Activ glass. Transient absorption spectroscopy showed that the innate electron–hole recombination dynamics are similar in brookite and anatase, akin to previous reports. The superior activity of the brookite film is hence attributed to the higher surface area compared to anatase.
A simple, economical and effective solution-based chemical vapour deposition (CVD) technique, aerosol-assisted CVD, has been successfully applied to produce inexpensive Cl-doped ZnO films using Zn acetate dihydrate and FeCl3. X-ray photoelectron spectroscopy and the increase in cell parameters from powder X-ray diffraction determined that Cl had been doped into the wurtzite ZnO lattice. The Cl-doping had a significant effect on the morphology of the thin films synthesised and resulted in an improvement in the visible light transmission and lower electrical resistance (typical resistivities of doped films ∼10−2 Ω cm). The highest transmittance (% T) of 85% was obtained when 7 mol% FeCl3 was used in the precursor solution and the lowest resistivity of 4.28 ± 0.41 × 10−2 Ω cm was obtained with 5 mol% FeCl3. The greatest photocatalytic activity of stearic acid degradation under UVA irradiation was obtained on using 10 mol% FeCl3, resulting in the highest formal quantum efficiency (FQE) of 3.0 ± 0.1 × 10−4 molecule per photon. These films, therefore, display transparent conducting oxide and photocatalytic properties, giving multifunctional characteristics and promising applications.
ZrO2–TiO2 composite thin film deposited via aerosol assisted chemical vapour deposition showed enhanced photocatalytic activity compared to pure anatase TiO2. The photocatalytic properties were determined using resasurin redox dye.
This study reports enhanced PEC performance of TiO 2 /α-Fe 2 O 3 heterostructure films made via sequential AACVD of hematite (450 °C) followed by APCVD of anatase TiO 2 with controlled thickness.