Distributed Acoustic Sensing (DAS) has become a popular method of observing seismic wavefields: backscattered pulses of light reveal strains or strain rates at any location along a fiber‐optic cable. In contrast, a few newer systems transmit light through a cable and collect integrated phase delays over the entire cable, such as the Microwave Frequency Fiber Interferometer (MFFI). These integrated systems can be deployed over significantly longer distances, may be used in conjunction with live telecommunications, and can be significantly cheaper. However, they provide only a single time series representing strain over the entire length of the fiber. This work discusses theoretically how a distributed and integrated system can be quantitatively compared, and we note that the sensitivity depends strongly on points of curvature. Importantly, this work presents the first results of a quantitative, head‐to‐head comparison of a DAS and the integrated MFFI system using pre‐existing telecommunications fibers in Athens, Greece.
24 February 2012 in IEEE Photonics Technology Letters
In this letter, the discrete Fourier transform-spread discrete multitone modulation (DFT-spread DMT) scheme has been used for the first time in laser-based short range optical transmission (over 100 m) with 1-mm step-index plastic optical fiber link, and its superior performance, compared with the standard DMT scheme, was demonstrated. The DFT-spread DMT combines the advantages of both single carrier and multicarrier transmission together with a lower peak-to-average power ratio. Under the same experimental conditions, a lower bit-error-rate is achieved with DFT-spread DMT compared with standard DMT for transmission rates in the 1-Gb/s range.
We propose and experimentally validate a new cost-effective optical receiver–regenerator scheme for long-distance microwave-frequency standard dissemination, based on the properties of dual-wavelength injection locked Fabry–Perot (FP) lasers. The regenerator FP laser is injection locked to one of its longitudinal modes by the incoming intensity-modulated light carrying the microwave-frequency standard. The light of a local CW laser is also injected in the regenerator FP, locking it to an adjacent mode. The dual-injection locked laser reproduces the sinusoidal microwave-frequency standard on both wavelengths. The regenerated original signal is transmitted to the next node, whilst the local wavelength is fed back to the previous node for phase error extraction and link compensation. The performance of the proposed regenerator is demonstrated with Allan deviation and phase-noise measurements.
12 April 2017 in IEEE Photonics Technology Letters
The fundamental properties of free space optical channels in the ultraviolet (UV) spectral range between 200 and 280 nm are the enhanced scattering and the solar blind operation. Exploiting these properties, point-to-point links in a non-line-of-sight (NLOS) regime were experimentally tested and the performance of pulse position modulation of fourth order (4-PPM) and flip-orthogonal frequency division multiplexing (Flip-OFDM) modulation formats was evaluated. At the transmitting side, light-emitting diodes (LEDs) emitting at 265 nm were used. At the receiving side, a photo-multiplier tube was combined with an optical filter. Distances up to 20 m were covered and kilobits/s rates were applied. The performance was also evaluated after modifying artificially the atmospheric conditions by the operation of a fog machine. In short, 4-PPM outperformed Flip-OFDM, whereas a medium that offers enriched scattering due to fog may boost the performance of short-range NLOS links in the UV spectral range.
The integration of QKD systems in metro optical networks raises challenges that cannot be fully resolved with current technological means. In this work, we devised a methodology for identifying different types of impairments for a QKD link embedded in a communication network. Identification occurs in real time using a supervised machine learning model designed for this purpose. The model takes only QBER and SKR time-series data as the input, making its applicability not restricted to any specific QKD protocol or system. The output of the model specifies the working conditions for the QKD link, which is information that can be valuable for users and key management systems.