A comprehensive study on the application of magneto-rheological (MR) damper in above knee prosthetic is introduced. The stance phase and the swing phase were studied. The knee model was composed of four-bar prosthetic knee mechanism with an MR damper. The equations of motion, of the model, were obtained using Newton's second law at the sagittal plane. To avoid the difficulties of the inverse dynamics, due to the damper’s nonlinear characteristics, a simplified approach was suggested for the Spencer model. This simplified approach was used to calculate the input voltage to the damper to obtain the desirable control force. The input data was obtained from the experimental work by sticking surface land marks to the artificial leg and filming it during performance of the daily activity. The Stream pix, AVI Edit, and WINanalyze software were used to calculate the global kinematics, for the required surface land marks, at each frame of the recorded motion. The model results represent the voltage required for the MR damper, during most daily activities, of a person who uses this kind of an artificial leg. The results showed that the required voltage depends on displacement, velocity and calculated force.
A small amount of natural frequency deviation extremely decreases the output power. So, a multi-mass single harvester (bending harvester) was utilized to enlarge the bandwidth of the natural frequency. We constructed three models to study the effect of increasing the concentrated masses on increasing the bandwidth natural frequency. We used Finite Element Metho (FEM (COMSOL to model and simulate the three models. Moreover, we constructed an L-shaped harvester with concentrated masses to compare the rectangular harvester with concentrated masses. The results prove that increasing the number of concentrated masses increases the output power and broadband natural frequency. Moreover, the results indicate that the harvester cantilever with concentrated masses gives more output power and broadband than the L- shaped harvester for the same volume. Also, our research studied the harvester parameter effects on the output power. This study found that the increase in beam length and mass height increases the output power while the increase in piezoelectric thickness and damping ratio decreases the output power and bandwidth frequency. We validated our proposed model through a comparison with others’ preceding experimental results and it showed a good agreement. The harvester with a high width/length ratio gives a larger wideband natural frequency.
30 August 2022 in International Maritime Transport and Logistic Journal