This paper presents a review of the recent work assessing the performance of building structures strengthened with engineered cementitious composite (ECC). ECC characterizes tensile strain hardening and multiple cracking properties, as well as strong interfacial bonding performance with substrate concrete, which makes it a promising retrofitting material. A lot of researches have been conducted on reinforced concrete (RC) structures, including beams, columns, beam–column joints, and fire-damaged slabs, strengthened with ECC material, and an extensive collection of valuable conclusions were obtained. These strengthening systems usually combine ECC with FRP textiles or steel bars to form a composite strengthening layer. The review demonstrates that ECC strengthening can greatly improve the performance of RC structures.

To improve the greenness and deformability of engineered cementitious composites (ECC), recycled powder (RP) from construction and demolition waste with an average size of 45 μm and crumb rubber (CR) of two particle sizes (40CR and 80CR) were used as supplements in the mix. In the present study, fly ash and silica sand used in ECC were replaced by RP (50% and 100% by weight) and CR (13% and 30% by weight), respectively. The tension test and compression test demonstrated that RP and CR incorporation has a positive effect on the deformability of ECC, especially on the tensile strain capacity. The highest tensile strain capacity was up to 12%, which is almost 3 times that of the average ECC. The fiber bridging capacity obtained from a single crack tension test and the matrix fracture toughness obtained from 3-point bending were used to analyze the influence of RP and CR at the meso-scale. It is indicated that the replacement of sand by CR lowers the matrix fracture toughness without decreasing the fiber bridging capacity. Accordingly, an explanation was achieved for the exceeding deformability of ECC incorporated with RP and CR based on the pseudo-strain hardening (PSH) index.

Fiber-reinforced polymer (FRP) has supreme resistance to corrosion and can be designed with optic fibers. FRP can be an alternative to steel reinforcement for concrete structures, and can serve as a sensor for smart concrete structures. Due to poor cracking control and bond performance, the limit of flexural capacity in the serviceability limit state has not been determined, which has obstructed the wider application of FRP bars in smart structures. In this study, in order to overcome these shortcomings, a new engineering cementitious composite (ECC) with superior tensile strain capacity was used to replace the cover around the FRP bars in the tensile zone. To investigate the anti-cracking performance of the new composite beam, seven simply supported beams were designed. In the preliminary investigation, the longitudinal FRP bars in these beams were designed without optic fibers to focus on the mechanical behavior. The beams were tested under four-point load and measured using the digital sensor technique, digital image correlation (DIC). The test results showed that introducing a new ECC layer on the tensile side improves the cracking control and flexural behavior (load capacity and deformability) of a FRP-reinforced sea sand and seawater concrete (SSC) beam, especially in the serviceability limit state. We demonstrate the new composite beam can steadily and fully improve the tensile capacity of FRP bars, which is the basis of using FRP bars as sensors.