Imaging and analyzing gunshot residue (GSR) particles using the scanning electron microscope equipped with an energy dispersive X-ray spectrometer (SEM-EDS) is a standard technique that can provide important forensic evidence, but the discrimination power of this technique is limited due to low sensitivity to trace elements and difficulties in obtaining quantitative results from small particles. A new, faster method using a scanning proton microbeam and Particle Induced X-ray Emission (μ-PIXE), together with Elastic Backscattering Spectrometry (EBS) is presented for the non-destructive, quantitative analysis of the elemental composition of single GSR particles. In this study, the GSR particles were all Pb, Ba, Sb. The precision of the method is assessed. The grouping behaviour of different makes of ammunition is determined using multivariate analysis. The protocol correctly groups the cartridges studied here, with a confidence >99%, irrespective of the firearm or population of particles selected.
Dislocation‐related photoluminescence at 0.806 and 0.873 eV is observed in erbium‐doped silicon epi layers grown by liquid‐phase epitaxy on (100) Si wafers. These signals are detected at T = 2 K only on epi layers deposited on Czochralski grown silicon substrates. No luminescence is observed when float zone‐grown substrates are used. The peak intensity shows temperature quenching, but the signal remains detectable up to 195 K.The luminescence apparently is due to dislocations in silicon in the simultaneous presence of high oxygen concentration and erbium impurities. A comparison with the typical infrared emission from erbium‐implanted silicon samples is presented.