This article presents a perceptual comparison of the loudness of a large range of 64 different typical “living room” sounds transmitted through two different walls: (1) a light-weight wall, composed of gypsum boards mounted on metal “C” studs and (2) a heavy-weight wall, built out of lime sand bricks plastered on one side. The two walls had different (laboratory measured) sound insulation spectra, but their Rw + C50−5000 rating was the same: 52 dB. Compared to the heavy-weight wall, the mass-spring-mass-type light-weight wall had better sound insulation properties in the middle frequency range and worse at low frequencies below 100 Hz and above 3150 Hz. Listening subjects had to choose the loudest stimuli between a pair of sounds (as transmitted through the lightweight and the masonry wall) presented through headphones in random order with one repetition, following a two-alternative forced choice (2AFC) procedure. Two sets of listening tests were conducted in this study, playing stimuli at realistic sound level and on artificially overall increased level. The listening experiments revealed significant differences in subjective assessment between the two types of acoustic insulation. The results also infer that the discussed single number rating does not adequately correspond with people’s perception.status: publishe
In large rooms, where many people gather such as atria, food courts or restaurants, relatively high noise levels can occur, due to so called “Lombard effect”. The “Lombard effect” is a reflex of vocal chords that relates to changes of the voice characteristics in noisy background. Typically an increase of the vocal intensity, the fundamental voice frequency, and the word duration will occur. Noise levels in an enclosed place are influenced not only by the amount and character of sound sources present, but also by the overall reverberation of sound in the space.This article deals with the investigation of the acoustic conditions in three large gathering places covered by glass and foils. We focus on the investigation of the influence of the amount and position of sound absorption in atria on their reverberation time and on the occurrence of various sound phenomena, such as flutter echoes, focusing of sound etc. Results of the measurements are used for calibration of acoustical models. Different architectural solutions simulated in ray-based software are compared
In this paper, with the aim of assessing the deterioration of speech intelligibility caused by a speaker wearing a mask, different face masks (surgical masks, FFP2 mask, homemade textile-based protection and two kinds of plastic shields) are compared in terms of their acoustic filtering effect, measured by placing the mask on an artificial head/mouth simulator. For investigating the additional effects on the speaker’s vocal output, speech was also recorded while people were reading a text when wearing a mask, and without a mask. In order to discriminate between effects of acoustic filtering by the mask and mask-induced effects of vocal output changes, the latter was monitored by measuring vibrations at the suprasternal notch, using an attached accelerometer. It was found that when wearing a mask, people tend to slightly increase their voice level, while when wearing plastic face shield, they reduce their vocal power. Unlike the Lombard effect, no significant change was found in the spectral content. All face mask and face shields attenuate frequencies above 1–2 kHz. In addition, plastic shields also increase frequency components to around 800 Hz, due to resonances occurring between the face and the shield. Finally, special attention was given to the Slavic languages, in particular Slovak, which contain a large variety of sibilants. Male and female speech, as well as texts with and without sibilants, was compared.