Photocatalytic activity in TiO2 attract great attention because it promising application in contaminations on degradation and energy conversation. However there is a need on TiO2 band gap modification to be equivalent with the visible light. Thus, inviting several method of addition certain elements including in this study, the additional of graphene oxide (GO) was investigated. GO were prepared by Hummer method before it was added into TiO2. The formation of GO from it graphite precursor had been confirmed by Raman spectroscopy. The existence of D-band at wavelength of 1328 cm-1 and G-band at 1573 cm-1 shows the formation of GO. The GO was then added in different concentration; 0.0 - 1.0 wt% into TiO2. The photocatalytic activity was determined using calculating the photodegradation efficiencies of methylene blue under UV light irradiation. The experimental results showed that the photodegradation of MB were increased with higher dopants concentration due to reduction of band gap energy of TiO2 from 3.2 eV to 3.0 eV for 1.0 wt% GO-with the photodegradation efficiency of GO doped TiO2 was 61.38%.
3 January 2022 in Chemical Engineering Research and Design
With a sharp increase in demand and production, palm oil wastes, (i.e. empty fruit bunches, fibre and shells) are generated, out of which a large amount ends up in landfill. In such a context, alternative solutions are needed to reduce the impact of these agricultural wastes on the environment. The present paper investigates the effect of addition of agricultural waste materials on the combustion behavior of its blends with metallurgical coke (MC). Two types of agricultural waste materials, palm shell and coconut shell, were mixed in different proportion with MC, while the gas phase reactions were studied at 1200°C in a drop tube furnace (DTF). In the tested conditions, the blends containing agricultural waste materials indicated higher combustion efficiencies compared to MC alone. Carbon structure analysis were performed through 13CP/MAS NMR spectroscopy showing various groups of carbons present in the agricultural waste samples ranging from aliphatic to aromatic carbons. The morphology of the samples was studied through Scanning Electron Microscope (SEM). SEM provided a qualitative description of the pore structure in the raw samples as well as the changes occurring following the gas phase reactions in the DTF. It was found that the particles derived from the wastes became increasingly deformed and lost their cell lumen. Surface area measurements were found to be in good agreement with the SEM images, supporting the higher combustion efficiency of the blends in comparison to coke alone. The present study suggests that agricultural waste materials have the potential to partially replace MC, as an auxiliary fuel in metallurgical processes.
1 April 2019 in Journal of Materials Research and Technology