Almaz Kuandikov

Dr. Almaz Kuandikov

orcid

Research Focus & Metrics

Academic Career Length

3Years (2024-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
2 February 2025 in Engineering, Technology & Applied Science Research
Verified
Journal Article
Open access
PDF file
PBPetr Bykov
Petr Bykov
AKAlmaz Kuandikov
Almaz Kuandikov
AKAinagul B. Kaliyeva
Ainagul B. Kaliyeva
ESEduard Siemens
Eduard Siemens
This article presents the findings of experimental studies on the involvement in the processing of spent filters from ash and slag waste used in the refining of primary aluminum as a filler for concrete production. The processing of spent granular filters was conducted in three stages. The first stage involved the preliminary processing of filter grains to remove aluminum scrap. The second stage entailed the metallurgical processing of separated aluminum scrap through remelting in an induction crucible furnace and subsequent refining. The third stage focused on the production of a concrete mixture comprising crushed spent filter grains, quartz sand, bauxite sludge, screenings of crushed rocks with a fraction of 20 mm–30 mm, and Portland cement. This mixture was used to create samples of building products. The test results indicate that the tensile strength of the concrete samples for building products ranges from 20.89 MPa to 37.75 MPa, depending on the Portland cement content. This strength corresponds to that of heavy concrete.

1 April 2024 in Russian Metallurgy (Metally)
Verified
Journal Article
Closed access
PDF file
PBP. O. Bykov
P. O. Bykov
VCV. A. Chaikin
V. A. Chaikin
AKAlmaz Kuandikov
Almaz Kuandikov
MSM. M. Suyundikov
M. M. Suyundikov
VSV. A. Salina
V. A. Salina
NKN. K. Kulumbaev
N. K. Kulumbaev
The processing of primary aluminum with boric acid in a ladle is subjected to thermodynamic analysis. The HSC Chemistry 9.0 (Outotec Technologies) software was used for calculations. The temperature range investigated in the calculations (650–950°C) corresponds to the production conditions of the Kazakhstan Electrolysis Plant. The pressure range is determined using the technological conditions of flux treatment of aluminum in a crane ladle with a working height of 2 m and ranged from 101.33 to 148.99 kPa. The presence of a solid phase and low process kinetics are characterized by the lower limit of the temperature range. The upper limit of temperatures demonstrates the conditions closest to the actual working conditions during electrolysis. The pressure at the metal melt surface is represented by the lower limit in the pressure range, and the pressure at the depth of flux immersion equivalent to 2 m is represented by the upper limit. The depth of the suspension immersion in the calculations is varied in the range 0.5–2 m. The thermodynamic analysis in the investigated range of temperatures and pressures unequivocally indicates that vanadium borides are more stable compared to aluminum borides; therefore, they will predominantly form in this temperature range. The stability order also suggests that vanadium can be easily removed from aluminum melts by adding boron.

30 September 2024 in Science and Technology of Kazakhstan
Verified
Journal Article
Closed access
PBPetr Bykov
Petr Bykov
АЖА. К. Жунусова
А. К. Жунусова
AKAlmaz Kuandikov
Almaz Kuandikov
РМР. Б. Муканов
Р. Б. Муканов
ЭСЭ. Сименс
Э. Сименс
Авторами проведен анализ возможности вовлечения в переработку железосодержащих отходов, образующихся при производстве глинозема из бокситов Казахстана с использованием альтернативных углероду (С и СО) восстановителей – водорода (H2) и метана (CH4). В данной статье представлены результаты первого этапа экспериментальных исследований по использованию кокса для восстановления минералов, входящих в состав железистых песков и отвальных шламов. Экспериментально установлено, что лимитирующей стадией процесса является процесс разделения образованных чугуна и шлака, который из-за высокого содержания оксидов алюминия в шлаке не протекает в полной мере при температуре 1200 – 1300 оС, что требует увеличения температуры протекания процесса до 1400 – 1500 оС и увеличения количества извести в рудоугольных брикетах. В работе запланированы дальнейшие исследования по восстановлению железа из железистых песков и отвальных шламов производства глинозема с использованием восстановителей альтернативных углероду (коксу). Исследования проводились в рамках грантового финансирования Комитета науки Министерства науки и высшего образования Республики Казахстан по конкурсу на грантовое финансирование по научным и (или) научно-техническим проектам на 2024-2026 годы по проекту АР23487674 «Комплексная переработка бокситов Казахстана с доизвлечением железа альтернативными восстановителями при реализации стратегии низкоуглеродистого развития». Ключевые слова: боксит, железо, глинозем, углеродная нейтральность, кокс, рециклиинг.

30 September 2026 in Science and Technology of Kazakhstan
Verified
Journal Article
Closed access
PBPetr Bykov
Petr Bykov
MSM. M. Suyundikov
M. M. Suyundikov
AKAlmaz Kuandikov
Almaz Kuandikov
RMR. B. Mukanov
R. B. Mukanov
SPS. Pochinok
S. Pochinok
The authors analyzed the feasibility of recycling iron-containing waste generated during alumina production from bauxite in Kazakhstan using reducing agents alternative to carbon (C and CO) – hydrogen (H2 ) and methane (CH4 ). This article presents a thermodynamic analysis of the reduction of iron minerals found in ferrous sands and waste sludge using reducing agents – C, CO, H2 , and CH4 . HSC Chemistry 9.0 software from Outotec Technologies was used for the thermodynamic calculations. The temperature range studied was 100–1500°C, and the pressure was 101.33 kPa. The thermodynamic analysis in the studied temperature and pressure range clearly demonstrates the feasibility of using hydrogen-based reducing agents alternative to carbon for iron recovery from alumina production waste in Kazakhstan, which will contribute to the achievement of the UN Sustainable Development Goals and carbon neutrality in the metallurgy industry. The research was conducted under a grant from the Science Committee of the Ministry of Science and Higher Education of the Republic of Kazakhstan under the competition for grant funding for scientific and/or scientific-technical projects for 2024–2026 under project AP23487674, «Comprehensive Processing of Kazakhstan’s Bauxites with Additional Iron Extraction Using Alternative Reductants in the Implementation of a Low-Carbon Development Strategy». Keywords: bauxite, iron, carbon neutrality, hydrogen, methane, recycling.

30 December 2025 in Science and Technology of Kazakhstan
Verified
Journal Article
Closed access
AKAlmaz Kuandikov
Almaz Kuandikov
The paper investigates the technology of refining primary aluminum from vanadium impurities, based on flux treatment with boron-containing fluxes. In the Pavlodar region of the Republic of Kazakhstan, on the basis of local enterprises, the production of primary aluminum and products based on local raw materials is developing. The main problem in the production of primary aluminum on the basis of JSC «Kazakhstan Electrolysis Plant» is the presence of undesirable vanadium impurities, which pass into metal during electrolysis from baked anodes based on calcined coke (vanadium content up to 800 ppm) of the local enterprise LLP UPNK-PV (Pavlodar, Kazakhstan). The authors investigated the process of ladle refining of aluminum from vanadium using the Al-B (3 % B) alloy. Laboratory and industrial tests have shown a decrease in the vanadium content by an average of 78 % in the bulk of the metal, with an increase in its content in volume up to 5–10 % of the ladle capacity. It was found that mixing leads to a certain averaging of the vanadium content in the ladle volume. Keywords: aluminum, metallic impurities, refining, vanadium, flux.

14 September 2026 in Alloys
Verified
Journal Article
Open access
PDF file
PBPetr Bykov
Petr Bykov
MSMerkhat Suyundikov
Merkhat Suyundikov
ABAlexey Bogomolov
Alexey Bogomolov
AKAlmaz Kuandikov
Almaz Kuandikov
AZAblay Zhunusov
Ablay Zhunusov
NKN. K. Kulumbaev
N. K. Kulumbaev
In this paper, we experimentally investigated the integrated processing of high-iron Kazakh bauxites by reducing smelting of ore–coke–lime briquettes to produce an Fe-Al-Si metallic alloy, which is of potential interest for steel deoxidation, together with calcium-aluminate slag, which is of potential interest for alumina extraction. Briquettes containing bauxite, metallurgical coke (10–20 wt.%), and freshly calcined lime (10 wt.%, constant) were melted in a muffle furnace at a temperature of 1200–1450 °C. Complete separation of metal and slag was achieved at 1400–1450 °C, whereas at 1200–1350 °C, separation remained incomplete. Changing the coke/bauxite mass ratio in the charge from 0.125 to 0.286 increased the total content of metallic Si, Al and Fe in the recovered metallic product from 77.1 to 98.66 wt.%, according to X-ray fluorescence (XRF) analysis after two-stage magnetic separation; the metallic product obtained with a coke/bauxite ratio of 0.286 in the charge contained 72.8% Fe, 23% Al and 2.86% Si (with minor impurities of Ti, Mn and Cr), while the associated slag was represented mainly by CaO (59.5%) and Al2O3 (34.0%). These slag characteristics indicate its potential suitability for alumina extraction or as a filler for structural concrete. The proposed route represents a potentially low-waste alternative for processing high-iron bauxites that are poorly suited to the classical Bayer process, avoiding the direct formation of red mud and supporting Kazakhstan’s transition toward closed-loop bauxite processing.