Cells sense and respond to the rigidity of their microenvironment by altering their morphology and migration behavior. To examine this response, hydrogels with a range of moduli or mechanical gradients have been developed. Here, we show that edge effects inherent in hydrogels supported on rigid substrates also influence cell behavior. A Matrigel hydrogel was supported on a rigid glass substrate, an interface which computational techniques revealed to yield relative stiffening close to the rigid substrate support. To explore the influence of these gradients in 3D, hydrogels of varying Matrigel content were synthesized and the morphology, spreading, actin organization, and migration of glioblastoma multiforme (GBM) tumor cells were examined at the lowest (500 µm) gel positions. GBMs adopted bipolar morphologies, displayed actin stress fiber formation, and evidenced fast, mesenchymal migration close to the substrate, whereas away from the interface, they adopted more rounded or ellipsoid morphologies, displayed poor actin architecture, and evidenced slow migration with some amoeboid characteristics. Mechanical gradients produced via edge effects could be observed with other hydrogels and substrates and permit observation of responses to multiple mechanical environments in a single hydrogel. Thus, hydrogel-support edge effects could be used to explore mechanosensitivity in a single 3D hydrogel system and should be considered in 3D hydrogel cell culture systems.
23 April 2019 in ACS Biomaterials Science & Engineering
Inert solid rocket propellant samples were subjected to dynamic inflation experiments, to characterize the viscoelastic response at high strain rates. An oxyacetylene‐driven shock tube created the shock wave, which was used to dynamically pressurize the surface of the samples during the inflation experiments. Two high‐speed cameras captured the deforming samples, which were speckled to measure the full‐field surface displacements using the digital image correlation (DIC) algorithm. An inverse finite element analysis (iFEA) was used to calibrate parameters of a generalized Maxwell model (i. e. Prony series), which was used to characterize the propellants’ viscoelastic response to shock wave exposure. The viscoelastic parameters calibrated using a Prony series with one Maxwell branch provided a better fit with the out‐of‐plane displacement data from DIC. At least 50 % of the energy dissipated, within the inert solid rocket propellant, occurred within 5 ms following shock wave exposure. The softening phenomenon, due to debonding of the particles embedded in the inert solid rocket propellant, occurred since there was a decrease in instantaneous elastic modulus with increased strain rate. The results of this study will add to the limited knowledge of the linear viscoelastic behavior of inert HTPB propellant at high strain rates and may improve the predictive capabilities of health‐monitoring sensors that assess the solid rocket propellant's structural integrity.