This paper presents studies on the processing of enrichment tailings as a component of a raw mixture in order to obtain cement clinker, with simultaneous distillation of zinc. Thermodynamic studies were carried out in the temperature range of 600–1600 °C using the software application “HSC Chemistry 6” developed by the metallurgical company Outokumpu (Finland). As a result of the conducted studies, we found that zinc contributes to the intensification of mineral formation of cement clinker. In particular, it was found that the formation of belite is possible in the temperature range from 990.7 to 1500 °C with Gibbs energy values of −0.01 and −323.8 kJ (which is better than the standard process by −11.4 kJ), respectively; the formation of alite is possible in the temperature range from 982.9 to 1500 °C with Gibbs energy values of −0.05 and −402.1 kJ (better than the standard process by −11.4 kJ), respectively; the formation of tricalcium aluminate is thermodynamically possible in the temperature range from 600 °C at ΔGTo = −893.8 kJ to 1500 °C at ΔGTo = −1899.3 kJ (better than the standard process by −1570.1 kJ), respectively; and the formation of four calcium aluminoferrite is possible in the temperature range from 600 °C at ΔGTo = −898.9 kJ to 1500 °C at ΔGTo = −1959.3 kJ (better than the standard process by −1570.2 kJ), respectively, with simultaneous distillation of zinc into a gaseous state for its further capture.
The present article presents the results of physical and chemical studies of opoka. In particular, the opoka was subjected to chemical analysis, X-ray phase, differential thermal analysis, scanning microscopy, and X-ray energy dispersive elemental microanalysis. The opoka was studied with the aim of using it as an available raw material for obtaining a sodium silicate mixture and, in the future, developing an energy-saving technology for obtaining a building heat-insulating and sound-insulating foam glass material based on it, using synthesis. As a result of the studies, the chemical composition of the opoka was determined, which is 69–80% represented by silica. The elemental composition of the opoka was established, which is represented by 94.25% oxides of Si, Al, and Fe. The presence of such oxides makes it an ideal raw material component of a silicate-sodium mixture for the subsequent synthesis of foam glass material from it. Experimental exploratory studies on the synthesis of foam glass based on opoka have been carried out. The experimentally obtained sample of foam glass material consists of 93.37% Si, Al, Mg, and Na oxides, has a porous structure with a pore size of 2–5 microns, an average density of 375 kg/m3, thermal conductivity of 0.063 W/(m °C) at 25 °C, and noise absorption of 51.6 Db.