Valentin Bekeshev

Dr. Valentin Bekeshev


Research Focus & Metrics

Academic Career Length

2Years (2025-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
14 February 2025 in Clean Technologies
Verified
Journal Article
Open access
PDF file
Sergey M FrolovSergey M Frolov
Sergey M Frolov
VSVictor Smetanyuk
Victor Smetanyuk
ISIlyas Александрович Sadykov
Ilyas Александрович Sadykov
ASAnton Silantiev
Anton Silantiev
FFFedor Frolov
Fedor Frolov
JIJaroslav O. Inozemtsev
Jaroslav O. Inozemtsev
A new high-temperature allothermal gasification technology is used to process three types of oil waste: ground oil sludge (GOS), tank oil sludge (TOS), and petcoke. The gasifying agent (GA), mainly composed of H2O and CO2 at a temperature above 2300 K and atmospheric pressure, is produced by pulsed detonations of a near-stochiometric methane-oxygen mixture. The gasification experiments show that the dry off-gas contains 80–90 vol.% combustible gas composed of 40–45 vol.% CO, 28–33 vol.% H2, 5–10 vol.% CH4, and 4–7 vol.% noncondensable C2–C3 hydrocarbons. The gasification process is accompanied by the removal of mass from a flow gasifier in the form of fine solid ash particles with a size of about 1 μm. The ash particles have a mesoporous structure with a specific surface area ranging from 3.3 to 15.2 m2/g and pore sizes ranging from 3 to 50 nm. The measured wall temperatures of the gasifier are in reasonable agreement with the calculated value of the thermodynamic equilibrium temperature of the off-gas. The measured CO content in the off-gas is in good agreement with the thermodynamic calculations. The reduced H2 content and elevated contents of CH4, CO2, and CxHy are apparently associated with the nonuniform distribution of the waste/GA mass ratio in the gasifier. To increase the H2 yield, it is necessary to improve the mixing of waste with the GA. It is proposed to mix crushed petcoke with oil sludge to form a paste and feed the combined waste into the gasifier using a specially designed feeder.

4 August 2026 in Preprints.org
Verified
Preprint
Open access
PDF file
AKAlexander Kopylov
Alexander Kopylov
ACAnastasiya Valerievna Cherkasova
Anastasiya Valerievna Cherkasova
ISIlya Shershnev
Ilya Shershnev
VBValentin Bekeshev
Valentin Bekeshev
NANadezhda Aksenova
Nadezhda Aksenova
ASAnna B Solovieva
Anna B Solovieva
Calcium alginate (CaA) xerogels and aerogels were evaluated as carriers for Rose Bengal (RB) in singlet-oxygen-generating systems intended for photodynamic applications. Xerogels were obtained by air-drying hydrogels, xerogels(A) by replacing water in the hydrogels with isopropanol followed by air drying, and aerogels by drying in supercritical carbon dioxide the corresponding alcogels, obtained by replacing water in the hydrogels with isopropanol. Hybrid CaA/polyvinylpyrrolidone (PVP) matrices were also prepared. Nitrogen sorption showed that the CaA xerogels(A) were mesoporous, with a specific surface area of SBET~225 m2/g and a mean pore diameter of approximately 9.3 nm; the corresponding SBET values were approximately 300 m2/g for the aerogels and below 1 m2/g for the xerogels. RB introduced during xerogel formation from water was retained in the matrix and was not released into phosphate-buffered saline (PBS, pH 7.2). By contrast, RB loaded from isopropanol was released from the xerogels(A) and aerogels, with the fastest release observed for CaA aerogels. RB incorporated into xerogels(A) and aerogels retained singlet-oxygen-generating activity. In air, the highest luminescence response was observed for RB immobilized in hybrid CaA/PVP aerogel films containing approximately 10 wt% PVP.

19 August 2026 in Gels
Verified
Journal Article
Open access
PDF file
AKAlexander Kopylov
Alexander Kopylov
ACAnastasiya Valerievna Cherkasova
Anastasiya Valerievna Cherkasova
ISIlya Shershnev
Ilya Shershnev
VBValentin Bekeshev
Valentin Bekeshev
NANadezhda Aksenova
Nadezhda Aksenova
ASAnna Solovieva
Anna Solovieva
Calcium alginate (CaA) xerogels and aerogels were evaluated as carriers for Rose Bengal (RB) in singlet-oxygen-generating systems intended for photodynamic applications. Hybrid CaA/polyvinylpyrrolidone (PVP) matrices were also prepared. Nitrogen sorption showed that the CaA xerogels(A) were mesoporous, with a specific surface area of SBET ~225 m2/g and a mean pore diameter of approximately 9.3 nm; the corresponding SBET values were approximately 300 m2/g for the aerogels and below 1 m2/g for the xerogels. RB introduced during xerogel formation from water was retained in the matrix and was not released into phosphate-buffered saline (PBS, pH 7.2). By contrast, RB loaded from isopropanol was released from the xerogels(A) and aerogels, with the fastest release observed for CaA aerogels. RB incorporated into xerogels(A) and aerogels retained singlet-oxygen-generating activity. In air, the highest luminescence response was observed for RB immobilized in hybrid CaA/PVP aerogel films containing approximately 10 wt% PVP. These findings suggest that such systems hold promise for applications in photodynamic therapy of superficial skin injuries. Xerogels(A) are also attractive carrier candidates because they avoid supercritical drying and, for the CaA xerogel(A) studied here, released 50% of the loaded RB within approximately 5 min.