Currently, the primary method for controlling red tides in the ocean involves spraying water solutions with special chemicals as solutes. High-pressure spraying results in the formation of typical jet structures. In this study, numerical simulation methods are employed to investigate the velocity variations, turbulent characteristics, and gas content distribution of jet flow fields under different initial jet flow pressures, cone angles, and nozzle diameters. Based on practical application scenarios, cluster analysis is used to explore the similarities and differences in jet equivalent diameters under different parameter conditions. The research findings indicate the following. (1) The difference of jet velocity distribution at the far field exit will be enlarged with the increase in the nozzle cone angle. When the nozzle cone angle is 4 mm, the velocity uniformity at the outlet is the best. (2) The TKE of the flow field has no consistent change law along the central axis. At the jet exit, the TKE shows an obvious multi-peak structure. (3) The gas content demonstrates a typical “double-valley” feature at the jet outlet cross-section. Increasing the initial pressure leads to a decrease in the gas content within the jet due to reduced entrainment, while the entrainment range remains largely constant. (4) Cluster analysis reveals that the similarity of jet flow width when it reaches the water surface is minimal compared to other operating conditions when the initial pressure is 0.36 MPa, the cone angle is 115°, and the nozzle diameter is 2 mm. All conditions can be categorized into two or three groups to ensure jet effectiveness. The study results provide scientific guidance for selecting spray devices for controlling red tides in the ocean.

The hazard of highly combustible marine oil leakage greatly increases fishing vessel operation risks. This research integrates an experiment to explore the coupling mechanism of a typical heated surface of an engine room as a source to ignite marine oil. A numerical model is established that depicts the dynamic process of and variations in the combined effects regarding multiple factors of oil ignition under actual experiment. The leaked marine oil is ignited with a heated surface, relevant models are applied to reproduce the results, and the influences of specific parameters of a fishing vessel’s engine room are analyzed. The results indicate that the leaked oil boils violently on the heated surface, and a vapor film forms on the oil surface. Increased heated-surface temperatures lead to a significant difference in the initial ignition occurrences of marine oil, and the distance between the ignition height and oil is closely related to the engine room environment. The ignition probability of marine oil shows a gradually increasing trend with elevated heated-surface temperatures. The ignition height presents a downward trend with the increase in the heated-surface temperature, while the engine room’s humidity in air inhibits the upward transfer of heat; however, the degree of inhibition is limited accordingly. The results evidence that this comparative work can be an effective approach to reveal the impacts of marine oil, heat source, ventilation velocity, and humidity on initial ignition characteristics. Additionally, this work provides a basis for setting up emergency planning with appropriate monitoring equipment and further preventing vessel fires due to oil–thermal ignition.

Ship resistance has a very important value in the determination of ship power and the design of emission standards. In this paper, a ship resistance model with different displacement, speed, and attachment under the condition of a fixed scale ratio is tested by means of experimental research, which is used to analyze the change law of ship resistance under the condition of a single factor. The coupling effects of multiple factors on the actual ship power are studied after the establishment of a mathematical relationship between the actual ship power and resistance on the basis of the response surface method. The research results show that: (1) there is an obvious positive correlation between ship resistance and speed, which matches the change law of the exponential equation. Compared with ship appendages, displacement and speed have the greatest influence on resistance. (2) According to the correlation analysis, the maximum correlation coefficient between ship speed/resistance and power is 0.99, and the correlation coefficients between displacement/resistance and power are 0.93 and 0.88, respectively. However, the correlation coefficients between ship appendages and resistance and power are only 0.23 and 0.14, respectively. (3) The actual ship power and speed, displacement, and appendages form a quadratic polynomial relationship. The multi-factor interaction analysis results show that speed and displacement have the greatest influence on the actual ship power. The research results have a certain guiding significance for ship design.