The aim of this paper was to develop and verify a method for evaluating the high-performance milling of Inconel 718 alloy under accelerated tool wear conditions. The method considered parameters such as cutting-force components, total machine power consumption, cutting-edge wear, and material removal rate. The study compared high-feed milling and plunge milling, using sets of cutting parameters that are appropriate for both techniques. The results indicate that high-feed milling was more efficient, achieving higher material removal rates and lower tool wear. On the other hand, plunge milling was characterized by a lower axial force component (Fz), which can positively affect machining accuracy. The paper highlights that the proposed evaluation method can also be applied to other hard-to-machine materials, and plunge milling offers a competitive alternative for roughing operations in the milling of Inconel 718 alloy.
1 September 2020 in Advances in Science and Technology Research Journal
The paper describes the problem of tool wear in machining processes. The importance of determining and analysing the demand of machining centres for electricity was emphasised and the potential relationship between tool wear and machine energy consumption was indicated. The paper presents the...
Presented are the results of diagnostic tests for three 3-axis vertical milling centers with different time of machining. An error analysis was carried out. Machine tool evaluation was made on the basis of error values and their suitability for carrying out machining tasks was determined.
1 September 2018 in Advances in Science and Technology Research Journal
The article discusses the importance of energy consumption for the modern machine tool. The research was carried out to show the influence of various cutting factors and parameters on the power consumption values of the machine tool. A special algorithm was developed to determine the actual energy consumption of the machine tool during the cutting process. The results of the study were compared with the algorithms of tool companies to determine the machine's power demand. The possibilities of using research conclusions to develop a more accurate method for assessing the energy demand of a machine tool in the cutting process were indicated.
Machining nickel-based superalloys, such as Inconel 718, poses a significant technological challenge due to their high-temperature strength and low thermal conductivity, leading to rapid tool wear. This paper presents a comprehensive comparative analysis of two roughing strategies: high-feed milling and plunge milling, utilizing a unique custom-designed milling head. The primary objective was to evaluate the impact of tool material reinforcement on the process by comparing SiC whisker-reinforced ceramic inserts (CW100) with non-reinforced inserts (CS300). The experiment involved measuring cutting force components, power consumption, and analyzing tool wear progression (VBB) and mechanisms. Results showed that the presence of the reinforcing phase is critical for reducing the axial force component (Fz), particularly in plunge milling, where CW100 inserts achieved a 30–35% force reduction and avoided the catastrophic failure observed in non-reinforced ceramics. Microscopic analysis confirmed that composite inserts undergo predictable abrasive wear, whereas CS300 inserts are prone to brittle fracture and spalling. Multi-criteria optimization using Grey Relational Analysis (GRA) identified high-feed milling with reinforced inserts as the most efficient strategy, while also positioning plunge milling with composites as a competitive, less energy-intensive alternative.