7 October 2020 in IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
Ultrasonic Time of Flight (ToF) measurement is commonly used in a variety of scenarios when using small bandwidth ultrasonic transducers with 40 kHz central frequency. With these transducers, threshold detection technique is commonly implemented, but the small bandwidth can cause inaccurate results. This article proposes a variant of correlation method for the improvement of the ToF measurement accuracy and stability with these transducers. Barker 13 and derived codes are proposed for this purpose, together with the selected code band narrowing techniques. The performance of these codes was evaluated experimentally, where 1000 measurements of each code and modulation schemes took place in a several fixed transmitter–receiver settings. As the main criterion for comparison of the performance of the codes and the threshold detection technique, a sample standard deviation (SSD) was selected, showing the stability of the measured results. The best results were produced by Quadriphase codes and codes with implemented fluent phase change technique, where the measured SSD was smaller than 20% of the SSD of the threshold detection techniques with all the used codes, and was also smaller than 10% for the best recorded cases.
19 February 2024 in IEEE Access
The article is mainly devoted to the analysis of the transient process during the phase change of the intra-impulse modulated signal of the system, which is composed of a pair of piezoelectric ceramic transducers. In the introductory part, this article is focused on the most accurate determination of the parameters of electrical equivalent circuit of piezoelectric ceramic transducers commonly available on the market of electrical components and less economically demanding. Based on the determination of these parameters, a system consisting of the piezoelectric ceramic transducer, transmitter - environment - piezoelectric ceramic transducer, receiver is then assembled and represented by transfer function. This system is subjected to simulation. An intra-impulse modulated signal with phase modulation is connected to the system input. The response to this signal is subsequently analyzed and compared with the real response of a real system. The goal is therefore to verify the suitability of the simulation model and, on the basis of this analysis, to determine the possibility of using specific piezoelectric ceramic transducers for application of intra-impulse modulated signal. As a method of verification, main parameter analysis of a cross-correlation function was selected. Based on this analysis it was found that this method is relevant for this purpose.