Přemysl Janů

Dr. Přemysl Janů

University of Defence, Brno, Jihomoravský Kraj, Czech Republic
orcid

Research Focus & Metrics

Academic Career Length

17Years (2010-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 May 2016
Verified
Conference Paper
Closed access
SDSang Van Doan
Sang Van Doan
JVJiri Vesely
Jiri Vesely
PJPřemysl Janů
Přemysl Janů
PHPetr Hubacek
Petr Hubacek
XTXuan Luong Tran
Xuan Luong Tran
Direction finding (DF) system using phase interferometer of long baselines gives high accuracy of angle of arrival (AOA), however, it also involves phase ambiguity and phase error. The paper presents a measurement of phase interferometer system, which was configured with three and four antenna elements, providing information of phase error. Moreover, a method including rotation of measured phase differences, labeling the phase lines and rounding value of phase difference was applied for determination of unambiguous AOA. The algorithm of AOA calculation was fast and optimized. The method was verified by experimental measurement combining with signal processing in MATLAB environment. The RMS error of phase measurement was 5.4° and RMS error of AOA determination was around 0.09°.


1 April 2016
Verified
Conference Paper
Closed access
SDSang Van Doan
Sang Van Doan
JVJiri Vesely
Jiri Vesely
PJPřemysl Janů
Přemysl Janů
PHPetr Hubacek
Petr Hubacek
XTXuan Luong Tran
Xuan Luong Tran
Phase ambiguity and phase error in interferometric method are important problems that have to be solved to determine angle of arrival (AOA) of signal. This paper proposes fast algorithm for ambiguity resolution of long baseline interferometric system, which was configured by three- and four-antenna array. In addition, the algorithm also provides information of allowable maximal error in phase measurement. The proposed algorithm also enables to configure a phase interferometric system. The algorithm was tested and verified by experimental results.

1 May 2015
Verified
Conference Paper
Closed access
SDSang Van Doan
Sang Van Doan
JVJiri Vesely
Jiri Vesely
PJPřemysl Janů
Přemysl Janů
The main aim of this work was to measure, verify and evaluate accuracy of target-location estimation in time difference of arrival (TDOA) method. Measuring workplace for TDOA measurement was assembled by using three receiving antennas, their distances were around 15 m each. Algorithm for solution of system of hyperbolic equations was created to determine position of signal source which is the intersection point of the hyperbolas. Position of signal source and its accuracy were graphically expressed.

7 October 2020 in IEEE Transactions on Ultrasonics, Ferroelectrics, and Frequency Control
Verified
Journal Article
Closed access
PDPavel Dycka
Pavel Dycka
PJPřemysl Janů
Přemysl Janů
JBJosef Bajer
Josef Bajer
RBRadek Bystricky
Radek Bystricky
Ultrasonic Time of Flight (ToF) measurement is commonly used in a variety of scenarios when using small bandwidth ultrasonic transducers with 40 kHz central frequency. With these transducers, threshold detection technique is commonly implemented, but the small bandwidth can cause inaccurate results. This article proposes a variant of correlation method for the improvement of the ToF measurement accuracy and stability with these transducers. Barker 13 and derived codes are proposed for this purpose, together with the selected code band narrowing techniques. The performance of these codes was evaluated experimentally, where 1000 measurements of each code and modulation schemes took place in a several fixed transmitter–receiver settings. As the main criterion for comparison of the performance of the codes and the threshold detection technique, a sample standard deviation (SSD) was selected, showing the stability of the measured results. The best results were produced by Quadriphase codes and codes with implemented fluent phase change technique, where the measured SSD was smaller than 20% of the SSD of the threshold detection techniques with all the used codes, and was also smaller than 10% for the best recorded cases.

21 April 2022 in Sensors
Verified
Journal Article
Open access
PDF file
Duong Van MinhDuong Van Minh
Duong Van Minh
JVJiří Veselý
Jiří Veselý
PHPetr Hubáček
Petr Hubáček
PJPřemysl Janů
Přemysl Janů
NPNhat Giang Phan
Nhat Giang Phan
In this paper, a new method for detecting and estimating the parameters of a binary phase shift keying (BPSK) signal, based on a cross-correlation function, is proposed. The proposed method consists of two stages. The first stage is used to detect or estimate a signal carrier frequency, and the second stage is used to estimate its pulse width or symbol rate. Firstly, the proposed method is investigated by use of a simulated BPSK signal in the form of Barker Codes 7, 11, and 13 in the MATLAB environment. Based on the simulation results, the functionality of this method is verified using a real-time BPSK signal generated by an E8267C generator. This is described in the second part of this paper. The experimental test results confirm that the proposed method is able to detect and estimate the parameters of all BPSK signals with SNR≥−21 dB.