Properties of high early-strength concretes (HESCs) containing Type V, Type III, and rapid hardening calcium sulfoaluminate (CSA) cements were investigated at curing ages of opening time, 24 h, and 28 days. Investigated properties included the fresh (workability, setting time, air content, unit weight, and released heat of hydration), mechanical (compressive and flexural strengths), transport (absorption, volume of permeable voids, water penetration, rapid chloride permeability, and accelerated corrosion resistance), dimensional stability (drying shrinkage), and durability (de-icing salt and abrasion resistance) properties. Test results revealed that the HESC containing Rapid-Set cement achieved the shortest opening time to attain the required minimum strength, followed by Type III and Type V cement HESCs. For the most part, Type V cement HESC produced the best transport and de-icing salt resistance, whereas Rapid-Set cement HESC displayed the best dimensional stability and wear resistance.
This study aimed to determine the abrasion resistance of ultra-high-performance concretes (UHPCs) for railway sleepers. Test samples were made with different cementitious material combinations and varying steel fiber contents and shapes, using conventional fine aggregate. A total of 25 UHPCs and two high-strength concretes (HSCs) were selected to evaluate their depth of wear and bulk properties. The results of the coefficient of variation (CV), relative gain in abrasion, and abrasion index of the studied UHPCs were also obtained and discussed. Furthermore, a comparison was made on the resistance to wear of the selected UHPCs with those of the HSCs typically used for prestressed concrete sleepers. The outcomes of this study revealed that UHPCs displayed excellent resistance against abrasion, well above that of HSCs. Amongst the utilized cementitious material combinations, UHPCs made with silica fume as a partial replacement of cement performed best against abrasion, whereas mixtures containing fly ash showed the highest depth of wear. The addition of steel fibers had a more positive influence on the abrasion resistance than it did on compressive strength of the studied UHPCs.
This investigation studied the retempering technique of remediation to mitigate the influence of combined transportation time and extreme hot and cold temperatures on plastic self-consolidating concrete (SCC). This method of remediation consisted of adjusting admixture dosage at the end of hauling to produce a matrix with similar fresh properties as those of the control concrete prepared at the temperature of 21°C and transportation duration of 10 minutes. Seven different temperatures (43, 36, 28, 21, 14, 7, and ) and five different hauling times (10, 20, 40, 60, and 80 minutes) were adopted. Polycarboxylate-based high-range water-reducing admixture (HRWRA) and viscosity-modifying admixture (VMA) were used to produce the selected matrices with slump flow of or , visual stability index (VSI) of 0 (highly stable concrete) and of 2 to 5 s. Laboratory test results revealed that the retempering method of remediation was successful in mitigating the adverse effect of combined hauling time and temperature on the flow characteristics of self-consolidating concrete.