Motivated by the high expectation for efficient electrostatic modulation of charge transport at very low voltages, atomically thin 2D materials with a range of bandgaps are investigated extensively for use in future semiconductor devices. However, researchers face formidable challenges in 2D device processing mainly originated from the out‐of‐plane van der Waals (vdW) structure of ultrathin 2D materials. As major challenges, untunable Schottky barrier height and the corresponding strong Fermi level pinning (FLP) at metal interfaces are observed unexpectedly with 2D vdW materials, giving rise to unmodulated semiconductor polarity, high contact resistance, and lowered device mobility. Here, FLP observed from recently developed 2D semiconductor devices is addressed differently from those observed from conventional semiconductor devices. It is understood that the observed FLP is attributed to inefficient doping into 2D materials, vdW gap present at the metal interface, and hybridized compounds formed under contacting metals. To provide readers with practical guidelines for the design of 2D devices, the impact of FLP occurring in 2D semiconductor devices is further reviewed by exploring various origins responsible for the FLP, effects of FLP on 2D device performances, and methods for improving metallic contact to 2D materials.

Semiconducting two-dimensional crystals are currently receiving significant attention because of their great potential to be an ultrathin body for efficient electrostatic modulation, which enables to overcome the limitations of silicon technology. Here we report that, as a key building block for two-dimensional semiconductor devices, vertical p–n junctions are fabricated in ultrathin MoS₂ by introducing AuCl₃ and benzyl viologen dopants. Unlike usual unipolar MoS₂, the MoS₂ p–n junctions show ambipolar carrier transport, current rectification via modulation of potential barrier in films thicker than 8 nm and reversed current rectification via tunnelling in films thinner than 8 nm. The ultimate thinness of the vertical p–n homogeneous junctions in MoS₂ is experimentally found to be 3 nm, and the chemical doping depth is found to be 1.5 nm. The ultrathin MoS₂ p–n junctions present a significant potential of the two-dimensional crystals for flexible, transparent, high-efficiency electronic and optoelectronic applications.

Turning many into one: Single-crystal metal foils are valuable for their surface properties that allow for synthesis of materials like graphene. Jinet al.present a strategy for creating colossal single-crystal metal foils called “contact-free annealing” (see the Perspective by Rollett). The method relies on hanging and heating commercially available, inexpensive, cold-rolled metal foils. Almost as if by magic, the polycrystalline grains rotate and anneal into a large single-crystal sheet with a specific crystal orientation. The strategy allows for the creation of much larger and much cheaper single-crystal metal foils.Science, this issue p.1021; see also p.996

Two-dimensional (2D) materials hold great promise for future nanoelectronics as conventional semiconductor technologies face serious limitations in performance and power dissipation for future technology nodes. The atomic thinness of 2D materials enables highly scaled field-effect transistors (FETs) with reduced short-channel effects while maintaining high carrier mobility, essential for high-performance, low-voltage device operations. The richness of their electronic band structure opens up the possibility of using these materials in novel electronic and optoelectronic devices. These applications are strongly dependent on the electrical properties of 2D materials-based FETs. Thus, accurate characterization of important properties such as conductivity, carrier density, mobility, contact resistance, interface trap density, etc is vital for progress in the field. However, electrical characterization methods for 2D devices, particularly FET-related measurement techniques, must be revisited since conventional characterization methods for bulk semiconductor materials often fail in the limit of ultrathin 2D materials. In this paper, we review the common electrical characterization techniques for 2D FETs and the related issues arising from adapting the techniques for use on 2D materials.