The present work shows the development of a comprehensive theoretical formulation for its application in the study of the internal flow of pressure-swirl atomizers with helical channels: “screw-conveyer”, which are characterized by presenting in their inlet channels, an angle of incidence or helix angle . This angle originates a trigonometric factor () that must be considered in the geometrical characteristics parameter of pressure-swirl atomizer (), which consequently involves other geometric parameters, such as the annular section coefficient (), discharge coefficient (), spray angle (), etc., being relevant in the internal flow study and design of the pressure-swirl atomizers type screw-conveyer. This theoretical formulation integrates an internal ideal flow model (Abramovich theory) with a model that considers the influence of the liquid viscosity (Kliachko theory) and hydraulic resistance of Idelchik. For the validation of this theoretical formulation, numerical simulation was used, considering the commercial software Ansys Fluent 2023 R2 furthermore, hexahedral meshes were generated with the ICEM CFD software 2023, for four cases of helix angle (, , and ), with application of the RNG k- turbulence model and VOF multiphase model (volume of fluid) for the location of the liquid-gas interface and spray angle visualization.
This study analyzes the feasibility of using pressure swirl atomizers at scale as energy generators. Likewise, the Ansys Fluent numerical simulation tool was used, configured based on the Volume of Fluid (VOF) multiphase model and six DOF motion for rigid bodies. In turn, three configurations of feeding flow were tested: upper manifold, lower manifold, and dual manifold. The numerical results show that it is possible to produce mechanical energy with 29.4% and 32.9% efficiency (using the SST k- and k- turbulence model, respectively), while generating a uniform spray effect at the outlet of the atomizer, even though this has certain ovoid-type deformities. Likewise, it was found that the addition of an internal rotor to the swirl chamber caused the generation of a very low-pressure contour, leading to an increase in the mass flow consumption of the atomizer. Also, four cases were analyzed, considering a hydraulic supply of both manifolds: 250 kPa, 300 kPa, 350 kPa, and 400 kPa, in order to obtain the characteristic curve of the turbine depending on the mass flow obtained for each case. Finally, this research proves how viable the use of this type of technology is in the field of renewable energy generation and the impact on its performance under different configurations of hydraulic supply.
The present article delves into the comprehensive study of internal flow dynamics within a cryogenic chamber used for freezing food with high water percent. For cryogenic freezing is necessary to reduce temperature extremely and maintain a uniform distribution, different behaviours may cause structural damages on food. This is because the chamber comprises a circular-sectioned tunnel or chamber coupled with a set of Jet-type atomizers for the injection of liquid nitrogen. The internal flow, predominantly consisting of liquid nitrogen, necessitates prolonged residency within the chamber to uniformly and effectively cool or freeze food traversing its interior. Consequently, the primary aim is to extend the cryogenic fluid's residence time, achieved by strategically decelerating the flow. This deceleration is orchestrated through the strategic injection of the fluid to induce a swirling or vortex effect. The formation of this effect is meticulously executed by positioning the atomizers at periodic intervals around the internal walls of the cylindrical chamber, ensuring a prolonged recirculation of the internal flow. This research endeavour is further augmented by a comprehensive numerical analysis of swirling flow dynamics and associated parameters such as temperature, velocity, pressure and nitrogen-liquid interface. Leveraging the robust capabilities of CFD ANSYS software (Computational Fluid Dynamics), this analysis incorporates sophisticated models including the Volume of Fluid (VOF) model and the k-epsilon turbulence model. Additionally, the construction of a three-dimensional hexahedral mesh, facilitated by ICEM CFD software, adds depth and precision to the numerical simulations. The culmination of this study lies in the profound comprehension of internal flow behaviour and its intrinsic correlation with the design intricacies of the cryogenic system. Variations in nitrogen injection pressures and the strategic deployment of atomizers around the chamber serve as pivotal parameters for elucidating the system's optimal design