Although solubility-pH data for desipramine hydrochloride (DsHCl) have been reported previously, the aim of the present study was to critically examine the aqueous solubility-pH behavior of DsHCl in buffer-free and buffered solutions, in the presence of physiologically-relevant chloride concentration, using experimental practices recommended in the recently-published "white paper" (Avdeef et al., 2016). The computer program pDISOL-X was used to design the structured experiments (pH-RSF method), to process the data, and to refine the equilibrium constants. Low-to-high and high-to-low pH assays (using HCl, H3PO4, or NaOH to adjust pH) were performed on phosphate-buffered (0.12‑0.15 M) saturated solutions of DsHCl in the pH 1.3-11.6 range. After equilibration (stirring 6 h, followed by 18 h stir-free sedimentation), filtration or centrifugation was used for phase separation. Concentration was measured using HPLC with UV/VIS detection. The 2:1 drug-phosphate solubility product (Ksp2:1 = [DsH+]2[HPO42-]) was determined from data in the pH 4-9 region. The free base of desipramine was prepared and used to determine the Ksp1:1 ([DsH+][H2PO4-]) in chloride-free acidified suspension. In addition, phosphate-free titrations were conducted to determine the intrinsic solubility, S0, and the 1:1 drug-chloride solubility product, KspDsHCl = [DsH+][Cl-]. Under the assay conditions, only the phosphate-free solutions showed some supersaturation near pHmax 8.0. In phosphate-containing solutions, pHmax was indicated at higher pH (8.8-9.6). Oils mixed with solids were observed to form in alkaline solutions (pH > 11). Notably, soluble drug-phosphate complexes appeared to form below pH 3.9 and above pHmax in saturated phosphate‑containing saline solutions. This was indicated by the systematic pH shift to higher values in the log S-pH curve in alkaline solution than expected from the Henderson-Hasselbalch equation. For pH < 3.9, saturated phosphate-containing saline solutions exhibited elevated solubility, with drug-hydrochloride as the sole precipitate. Salt solubility products, intrinsic solubility, and complexation constants, which rationalized the data, were determined. Elemental, thermogravimetric (TGA), differential scanning calorimetric (DSC), and powder X-ray diffraction (PXRD) analyses were used to characterize the precipitates isolated from suspensions at different pH.

A novel method is successfully tested for non-covalent imprinting. Conditions are used which practically exclude the formation of prepolymerization complexes. The template is cholesterol, and no so-called functional monomer is used. The polymers contain only an acrylic diester crosslinker. The porogen isopropanol prevents even hydrogen bonding between the template and the monomer in the prepolymerization solution. Despite of these apparently very disadvantageous conditions, appreciable imprinting factors for cholesterol and imprinted selectivity against some other steroids are observed, similar to other cholesterol MIPs with proven analytical usefulness.

Background/Objectives: Clofazimine (CFZ) is a Biopharmaceutics Classification System (BCS) II drug introduced in the US market in 1986 for the treatment of leprosy. However, CFZ was later withdrawn from the market due to its extremely low aqueous solubility and low absorption. In the literature, the intrinsic solubility of CFZ has been estimated to be <0.01 μg/mL, and solubilities of its different salt forms in simulated gastric and intestinal fluids are 10 mg/mL in the presence of 5 M glutaric acid could be called supersolubilization when compared to the intrinsic solubility of the basic drug. Such an increase in CFZ solubility and the conversion of the glutarate adduct to an amorphous state are being exploited to develop rapidly dissolving dosage forms.