The ring stain phenomenon is a critical hindrance to the distribution of the solute during drying for biochemical assays and materials deposition. Herein, we developed a substrate, characterized with hydrophilic spots surrounded by hydrophobic areas, to suppress the ring stain effect, and fabricated four kinds of patterned surfaces to investigate the relationship between the surface free energy and ring-suppressing performance. We found that during the evaporation process, a drop was constrained on the hydrophilic spot with a pinned contact line, and the ring stain effect was suppressed significantly. The suppressing performance of the ring stain effect increases with surface free energy differences between the hydrophilic and hydrophobic regions.

Transport and deposition of copper in the Earth's crust are mainly controlled by the solubility of Cu-bearing phases and the speciation of Cu in magmatic-hydrothermal fluids. To improve our understanding of copper mobilization by hydrothermal fluids, we conducted an experimental study on the interaction between Cu-bearing phases (metallic copper, Cu2O, CuCl) and aqueous chloride solutions (H2O ± NaCl ± HCl; with Cl concentrations of 0 to 4.3 mol kg-1). The experiments were run in rapid heat/rapid quench cold-seal pressure vessels at 800 °C, 200 MPa, and logfO2 ~ NNO+2.3. Either Cu or Au capsules were used as containers. The reaction products were sampled in situ by the entrapment of synthetic fluid inclusions in quartz. Fluid composition was subsequently determined by analyzing individual fluid inclusions using a freezing cell and laser ablation inductively coupled plasma-mass spectrometry. Our results show that large isolated and isometric inclusions, free of late-stage modifications, can be preserved after the experiment even when using a high cooling rate of 25 K s-1. The obtained results demonstrate that: (1) reaction between native Cu, NaCl solution, and quartz (± silica gel) leads to the coexistence of fluid inclusions and Na-bearing silicate melt inclusions. Micrometer-to submicrometer-sized cuprite (Cu2O) crystals have been observed in both types of the inclusions, and they are formed most probably due to the dissociation of CuOH. (2) When Cu0 reacts with HCl and CuCl solutions, or Cu+ reacts with NaCl solution, nantokite (CuCl) formed due to oversaturation has been found in fluid inclusion. Copper concentration in the fluid shows a strong positive dependence on the initial chlorine content, with Cu/Cl molal ratios varying from 1:9 to 1:1 in case 1 and case 2, respectively. When Cl is fixed to 1.5 m, initial fluid acidity has a major control on the Cu content, i.e., 0.17 ± 0.09 and 1.29 ± 0.57 m Cu were measured in fluids of case 1 and case 2, respectively. Cu solubility in pure water and in 1.5 m NaCl solutions are 0.004 ± 0.002 and 0.16 ± 0.07 m, respectively. The main responsible Cu-bearing complexes are CuOH(H2O)x in water, NaCuCl2 in NaCl solutions and HCuCl2 in alkali-free solutions. These results provide quantitative constraints on the mobility of Cu in hydrothermal solutions and confirm that Cl is a very important ligand responsible for Cu transport. The first observation that silicate melt can be generated in the fluid-dominated and native-copper-bearing system implies that transitional thermosilicate liquids can coexist with metal-rich fluids and may enhance Cu mobility in magmatic-hydrothermal systems. This may have important implications for the formation of Cu deposits in the systems with low S activities.

The Kalatag mineralization belt is an important metallogenic belt of polymetallic mineral deposits in the northern part of eastern Tianshan, and its age and tectonic setting are still controversial. We identified a set of Devonian volcanic rocks hosted in the Early Palaeozoic package of dominantly marine sediments with a small amount of terrestrial rocks. This study presents petrological, U–Pb geochronology, and geochemical data for the volcanic rocks. The ages of the rhyolite (407.2 ± 1.9 Ma) and basaltic andesite (380.4 ± 2.8 Ma) suggests that the Kalatag belt is a Devonian volcanic succession. These rocks consist mainly of marine calc–alkaline lava, tuff, pyroclastic rocks, and minor terrestrial basaltic andesite. The lavas are characterized by the enrichment of light rare earth elements and strongly depleted in Nb and Ta, typical of island arc magmatic rocks. The volcanic rocks probably originated from the partial melting of the mafic lower crust which was modified by subducted slab-related fluids. During their ascent through the crust, these volcanic rocks underwent variable extents of fractional crystallization (rhyolites) and crustal contamination (basaltic andesites). Combined with the results of previous studies, we suggest that the Devonian rocks formed in an island arc related to the northward subduction of the Northern Tianshan Ocean with a crustal thickness of ~35–40 km.