The aim of this paper is to present methods for corrosion mitigation in molten salt environments. The corrosion of structural materials depends directly on the redox potential of the salt. When the redox potential of the salt is higher than the standard potentials of the elements constituting the structural materials, corrosion occurs. If the reverse is true, no corrosion is observed. Herein, a methodology for calculating the theoretical potential of a molten salt is provided and compared with experimental measurements. Three ways to mitigate corrosion by modifying the salt redox potential are proposed: (i) using a soluble/soluble redox system; (ii) using a potentiostatic method; and (iii) using an amphoteric compound such as UCl₃, TiCl₂, or TiCl₃. Immersion tests were conducted under the above conditions to validate the methodology.

Portland cement is extensively used for the conditioning of radioactive waste. However, its high alkalinity is a serious obstacle to the stabilization of waste containing aluminum metal since aluminum is oxidized by the pore solution with the production of dihydrogen. This work investigates the potential of an alternative binder, magnesium potassium phosphate (MKP) cement, for the stabilization of Al–Mg alloys comprising 2 to 4.5 wt% of Mg and other metallic impurities. The objective is to assess the influence of the alloy composition on its reactivity in the cementitious matrix at earlier ages, as well as at later ages, when the cement has reached a significant reaction degree. Two complementary techniques are used. Gas chromatography shows that the dihydrogen release, resulting from the corrosion process, is not influenced by the magnesium content in the alloy. Electrochemical impedance spectroscopy provides qualitative information about the corrosion but also makes it possible to assess the corrosion current using an equivalent electrical circuit linked to the kinetic parameters of the postulated corrosion mechanism. Over a one-year period, the corrosion current of the alloys, regardless of their Mg content, is reduced by almost three orders of magnitude in MKP mortar as compared to Portland-cement-based mortar.

Beryllium metal is used as neutron moderator and reflector or multiplier in certain types of fission or fusion reactors. Dismantling of these reactors will produce radioactive beryllium waste, classified as low- or intermediate-level waste, that will need to be stabilised and solidified before being sent to disposal. The cementation process is under consideration because it may offer a good compromise between simplicity of implementation, cost, and quality of the final cemented wasteform. Nevertheless, knowledge of the corrosion behaviour of Be metal in a cement-based matrix is still limited, partly due to the high toxicity of Be that complicates testing. This study thus investigates Be corrosion in cement suspensions using potentiometry, voltammetry, and electrochemical impedance spectroscopy. Among the five different investigated systems (Portland cement blended without or with 40 wt.% silica fume, calcium sulfoaluminate clinker blended without or with 15% anhydrite, and calcium aluminate cement), Portland cement blended with 40% silica fume and calcium sulfoaluminate cement comprising 15% anhydrite are the most effective in mitigating beryllium corrosion. They allow reduction in the corrosion current by factors of 4 and 50, respectively, as compared to Portland cement.