Semisubmersible floating structures are becoming the predominant understructure type for floating offshore wind turbines (FOWTs) worldwide. As FOWTs are erected far away from land and in deep seas, they inevitably suffer violent and complicated sea conditions, including extreme waves and winds. Mooring lines are the representative flexible members of the whole structure and are likely to incur damage due to years of impact, corrosion, or fatigue. To improve mooring redundancy at each azimuth angle around a wind turbine, a group of mooring lines are configured in the same direction instead of just one mooring line. This study focuses on the mooring failure problems that would probably occur in a realistic redundant mooring system of a semisubmersible FOWT, and the worst residual mooring layout is considered. An FOWT numerical model with a 3 × 3 mooring system is established in terms of 3D potential flow and BEM (blade element momentum) theories, and aero-hydro floating-body mooring coupled analyses are performed to discuss the subsequent time histories of dynamic responses after different types of mooring failure. As under extreme failure conditions, the final horizontal offsets of the structure and the layout of the residual mooring system are evaluated under still water, design, and extreme environmental conditions. The results show that the transient tension in up-wave mooring lines can reach more than 12,000 kN under extreme environmental conditions, inducing further failure of the whole chain group. Then, a deflection angle of 60° may occur on the residual laid chain, which may bring about dangerous anchor dragging.
The poor maneuverability inherent to large ships is a non-negligible problem that restricts the development of the shipping industry, as large ships can only cruise at an excessively conservative speed when they encounter complicated traffic conditions; nevertheless, ship collision accidents still occasionally occur. In the present study, the novel concept of spoiler fins for modern large ships is proposed. In order to assess their effectiveness in enhancing ship maneuverability, a KRISO container ship (KCS) was selected to carry a pair of spoiler fins, after which a simplified simulation approach for saving the calculation resource was designed for ship collision avoidance conditions, and a full-scale numerical model, including the ship hull, fin, and fluid field domain, was established. Transient-state hydrodynamic forces were calculated during collision avoidance maneuvers using the CFD method; the pressure and velocity contours around the ship were demonstrated; and the ship motion trajectories under different initial ship speeds were simulated and predicted through the adoption of overset mesh and 6-DOF dynamic mesh techniques. Eventually, the improved course-changing performance, dependent on the spoiler fins, was validated.