High-aspect-ratio (HAR) microstructures on silicon (Si) play key roles in photonics and electromechanical devices. However, it has been challenging to fabricate HAR microstructures with slanting profiles. Here we report successful fabrication of uniform HAR microstructures with controllable slanting angles on (1 0 0)-Si by slanted uniform metal-assisted chemical etching (SUMaCE). The trenches have width of 2 µ m, aspect ratio greater than 20:1 and high geometric uniformity. The slanting angles can be adjusted between 2–70° with respect to the Si surface normal. The results support a fundamental hypothesis that under the UMaCE condition, the preferred etching direction is along the normal of the thin film catalysts, regardless of the relative orientation of the catalyst to Si substrates or the crystalline orientation of the substrates. The SUMaCE method paves the way to HAR 3D microfabrication with arbitrary slanting profiles inside Si.
Glass substrate, a new type of substrate with excellent mechanical and electrical properties of glass itself, has great potential to become an ideal platform for heterogeneous integration in chiplet systems for high-performance computing applications. The residual stress of the metal layer generated on the glass surface during the electroplating process is one of the major bottlenecks of glass packaging technologies, resulting in glass-metal layer delamination and glass breakage. This paper demonstrated for the first time a method to regulate the residual stress by manipulating the nanotwin directions of the electroplated Cu. The experimental results show that nanotwins with three different directions (non-directional, vertical, and horizontal) can be manipulated by controlling electroplating conditions (concentration of Cl− and gelatin, stirring speed). The orientations of non-directional, vertical, and horizontal nanotwinned Cu are non-oriented, 110 and 111, respectively. After electroplating, the 111-oriented nanotwinned Cu has the smallest residual stress (39.7 MPa). Annealing can significantly reduce the residual stress of nanotwinned Cu, which has been attributed to the decrease in the geometric necessity dislocation density. 110-oriented nanotwinned Cu had drastic recrystallization, while 111-oriented nanotwinned Cu and non-oriented nanotwinned Cu had only slight recrystallization. After annealing, the residual stress of 111-nt-Cu remains the lowest (29.1 MPa).
Through silicon vias are key components in 2.5D and 3D microelectronic packaging. Deep silicon etching is the critical step in fabrications of TSVs. Uniform metal-assisted chemical etching (MaCE) has been considered as a promising method to the conventional deep reaction ion etching for deep silicon etching. In this paper, we demonstrated that the uniform MaCE method is capable of fabricating vertical holes with a wide range of diameter of 5-100 μm for various TSVs applications. The Au catalysts in MaCE of large diameter features show slight deformation, possible due to a hindered transport of HF. We have further demonstrated that uniform vertical holes can be fabricated by MaCE using Au catalysts deposited from either e-beam evaporation or DC sputtering. The sputtered Au catalysts, reported for the first time, may carry separated Au particles etching laterally and produce pores on the sidewall of the etched holes. By optimizing the Au thickness, the sidewall etching could be minimized and uniform vertical etching profiles could be achieved. The DC sputtering method provides a fast and more accessible way for prototype tests in MaCE research and other researches where deep silicon etching is required.