Hybrid transparent electrodes with silver nanowires (AgNWs) and single-walled carbon nanotubes (SWCNTs) were fabricated on plastic films by a low-temperature solution process. The hybrid transparent electrodes exhibited a sheet resistance of 29.2 Ω/sq with a transparency of 80% when 6 wt.% of SWCNTs was mixed with AgNWs. This sheet resistance was less than one-fourth that of the AgNW transparent electrodes that were prepared using the same method. This reduction in sheet resistance is because the SWCNTs formed bridges between the AgNWs, thus, resulting in high conductivity of the hybrid transparent electrodes. The hybrid electrodes formed on plastic films exhibited high conductivity as well as excellent stability in sheet resistance when tested using a repeated bending test.
Despite the rapid progression of SiC power devices, the thermal characteristic evaluation during power cycling at high temperature (> 200 °C) is an issue. In this study, a fast and miniaturized evaluation system with on-line thermal characteristic measurement function was introduced by a n-doped 4H SiC thermal engineering group chip. On-line thermal resistance measurement of a power module structure by Ag micron/submicrron particles sinter joining and cooling system by a thermal interface material (TIM) bonding was profemed. High temperature reliability was systemically investigated by power cycling tests by switching on-off the power source which connected to the SiC-TEG chip by Au wires. The total thermal resistance of the power module from the SiC-TEG chip to the cooling system increased from 0.5 K/W to 0.53 K/W with the enhanced power source, and remained almost same after 20,000 power cycling at a swing temperature δTj of 150 °C. Furthermore, the SiC-TEG power module structure with the die attached with Pb and Pb-free solders, with the same power source as sinter Ag paste was also measured. The Ag sinter joint possesses the lowest thermal resistance and highest high temperature reliability during power cycling compared with Pb and Pb-free die attach materials.