There is several commercial software used to make contour plot, such as Surfer 8. While those softwares provide complete and advanced features, it is not easy to operate and not providing a basic understanding on the internal work of creating contour plot. For teaching purposes, those softwares are not the best choice because of that reasons, other than the high pricing. In this research, we develop a easy to use software to make contour plot, optimized for teaching purposes so that students can see the step by step of creating contour plot using common method. The result is software that can match the Surfer 8 at 78.29% accuracy, yet easy for student to operate.
1 November 2024 in Journal of Physics: Conference Series
Landslide mitigation is a primary concern in areas with significant elevation gradients. In addition to elevation, vegetation and hydrological factors also influence landslide potential. Therefore, this study analyzes landslide risk using satellite-derived vegetation data (NDVI). The results will be mapped to show relative susceptibility to landslides. The clustering method used is K-Means. NDVI data was obtained from NASA’s Terra and Aqua satellites, and the analysis is based on vegetation levels. The study identifies six areas in Garut where landslides frequently occur. The K-Means clustering process categorizes gridcodes 3 and 4 in the NDVI data as potential landslide zones due to sparse vegetation. The clusters are divided into three groups, with cluster 1 having a silhouette coefficient close to 1, indicating robust clustering. The mapping results highlight the North Garut area as having a high potential for landslides.
19 January 2016 in IOP Conference Series: Earth and Environmental Science
Graben (trench) is a natural expanse that is lower in altitude compared to its surrounding which is caused by normal faults shift. Changes in rock density can be identified to obtain the subsurface rock structure. Gravity method is a basic method yet very effective in determining subsurface rock structure. Identification of graben structure is the main focus of this research in order to identify the natural resources which may be available under the ground. Research work was performed in various locations in Bogor and according to our analysis using 2D Talwani model, the average density at the surface is 2.5 gram/cm3. 2D modelling results show a fault structure at rocks with relative direction West-East. The fault is forming an extension block faulting which makes the area a graben. In general, the crosssection profile of the model indicates rock layer structure made from limestone rocks (2.75 gr/cm3), sands, flakes, limestone (2.5 gr/cm3), volcanic sediment layer sandstone (2.3 gr/cm3), and clay layer and similar (2.00 - 2.10 gr/cm3).
Subang is an area which consists of hill and mountain. This area is also categorized as disaster-prone zone. An environment assessment should be carried out to prevent the landslide in the future. Sliding zone was associated with clay stones that were indicated by low resistivity zone. Technical measurements of resistivity method made are lateral mapping using the Wenner configuration with electrode spacing of 2 meter to reach the end point of the track along 60 meter. Resistivity values obtained in the range of 15-35 Ωm, 30-215 Ωm, and 250-1700 Ωm which indicated clay mixed with rock layer that dominates below the surface, clay sandy and alluvial were gathered. From the two dimension model, it can be concluded that in the study area reveal the sliding zone was located on upper the low resistivity zone.
10 June 2024 in Journal of Science Education and Technology
Educational robotics (ER) has the potential to be a novel approach to teaching geohazards such as earthquakes at the college level. ER, which provides learners with problem-solving settings, requires proficiency in content knowledge and practical application to address ill-defined problems, challenging learners to master problem-solving strategies. Despite several efforts in the existing literature, it is necessary to scaffold the problem-solving strategies comprehensively. This qualitative study investigated the problem-solving strategies of nine pre-service science teachers aligned with a coding scheme containing problem-solving strategies not previously documented together. The participants were assigned to construct a methane gas detector with Tinkercad to mitigate post-earthquake explosion risks for rescue teams in an online robotics-integrated earthquake professional development (PD) course. Qualitative data, including artifacts, observations, and interviews, were analyzed using deductive coding. The results indicated that participants predominantly employed trial and error, expert opinion, and case-based reasoning. They rarely utilized heuristics and intuition and did not use capacity evaluation, prediction, or sketching strategies. Furthermore, the study synthesized different problem-solving strategies into a comprehensive framework, which was used as a coding scheme. This framework helps to clarify problem-solving mechanisms in an ER context, offering a structured approach.