1 December 2016 in Journal of Mathematical and Fundamental Sciences
This paper reports the results of a study relating to the synthesis of a novel ternary CoFe2O4/CuO/CoFe2O4 thin film as a giant magnetoresistance (GMR) sensor. The CoFe2O4/CuO/CoFe2O4 thin film was prepared onto silicon substrate via DC magnetron sputtering with the targets facing each other. X-ray diffraction was used to determine the structure of the thin film and a 4-point method was used to measure the MR ratio. The GMR ratio is highly dependent on the ferrimagnetic (CoFe2O4) and nonmagnetic (CuO) layer thickness. The maximum GMR ratio at room temperature obtained in the CoFe2O4/CuO/CoFe2O4 thin film was 70% when the CoFe2O4 and the CuO layer had a thickness of 62.5 nm and 14.4 nm respectively.
17 May 2018 in Journal of Physics: Conference Series
1 November 2019 in Journal of Physics: Conference Series
The concentration of CO2 in soil and air is strongly influenced by temperature. When the temperature increase, the thermal energy will increase too and make the particle motion faster. In detecting CO2 gases, the MG-811 gas sensor has a high sensitivity in detecting CO2 gases in the air. The purpose of the research is characterized the electrical properties of MG-811 gas sensor toward temperature alteration. The used method is the experimental method, where the chamber is made of iron filled with CO2 derived from the CO2 gas tube. In the chamber has been paired digital thermometer and MG-811 gas sensor. The temperature alteration in the CO2 gas is regulated by the heater element attached to the chamber. The output of the MG-811 gas sensor will be processed by microcontroller, so it measures the CO2 concentration in units of parts per millions (ppm). The higher the measured temperature on the gas causes faster particle motion, the measured CO2 gas concentration is high and the resulting output voltage is low. But it happens if the temperature changes high, because the gas sensor response is slower than the temperature sensor used.
19 January 2016 in IOP Conference Series: Earth and Environmental Science
Graben (trench) is a natural expanse that is lower in altitude compared to its surrounding which is caused by normal faults shift. Changes in rock density can be identified to obtain the subsurface rock structure. Gravity method is a basic method yet very effective in determining subsurface rock structure. Identification of graben structure is the main focus of this research in order to identify the natural resources which may be available under the ground. Research work was performed in various locations in Bogor and according to our analysis using 2D Talwani model, the average density at the surface is 2.5 gram/cm3. 2D modelling results show a fault structure at rocks with relative direction West-East. The fault is forming an extension block faulting which makes the area a graben. In general, the crosssection profile of the model indicates rock layer structure made from limestone rocks (2.75 gr/cm3), sands, flakes, limestone (2.5 gr/cm3), volcanic sediment layer sandstone (2.3 gr/cm3), and clay layer and similar (2.00 - 2.10 gr/cm3).
14 March 2017 in IOP Conference Series: Materials Science and Engineering
Red blood has been of great interest for scientists since it relates to human' and living creature's life sustainability. One of the important compounds in red blood is porphyrin. Here, the purpose of this study was to develop a method for detecting porphyrin concentration using the assistance of giant magnetoresistance. In short of the method, we added Fe3+ solution to the porphyrin, and the mixed solution was introduced to the magnetic field. Next, the magnetized solution was introduced to the magnetic sensor to indicate the existence of porphyrin in the solution. To confirm the effectiveness of our method in detecting porphyrin, we varied the flow rate and concentration of Fe3+-modified porphyrin solution. The result showed that the more concentration and the slower flow rate affected the higher sensitivity gained. Since this developed method is simple but effective for detecting porphyrin concentration, we believe that further development of this method will be benefit for many applications, specifically relating to the medical uses.
12 August 2024 in PengabdianMu: Jurnal Ilmiah Pengabdian kepada Masyarakat
Student Worksheet (LKPD) is a learning tool that has a role in activating students in the learning process. This training aims to introduce technology that can support practicum as an optimization of the implementation of Physics practicum activities by utilizing the Physics Toolbox Sensor Suite application. The methods used in this activity include socialization, lectures, and discussions. Participants in this activity were Physics teachers totaling 46 people. This activity was conducted in three meetings. Participants received an introduction to the various features of the Physics Toolbox Sensor Suite application at the first meeting. Expert lecturers guided the trainees in the application of the tool in the second meeting. After receiving guidance, the trainees were directed to make the LKPD which would then be presented at the third meeting. This training produced six LKPDs with six different Physics materials. The results of the LKPD assessment by experts showed a very positive view of the quality of the LKPD. LKPD generated in this training is considered to have fulfilled all indicators of Science Process Skills (KPS). Through this activity, it can be concluded that the KPS-based LKPD assisted by the Physics Toolbox Sensor Suite application can be a practicum tool that facilitates the implementation of Physics practicum in schools that do not have or lack practicum tools. It is recommended that the use of laboratories and virtual laboratories can be conducted continuously to support Physics learning.