Currently, there are two primary issues with CFD simulations of local scour around bridge foundations using the RANS method. Firstly, the self-sustaining characteristics of turbulent boundary conditions at the inlet require special attention. Secondly, the simulated location of the maximum scour depth does not align with experimental observations. This paper employs the RANS method to model the hydrodynamic characteristics surrounding bridge piers. The sediment transport model and sediment-sliding model, considering any slope of the riverbed, were adopted to simulate the spatiotemporal evolution of local scour around the bridge foundation. Building on traditional methods and assuming local turbulence equilibrium, a self-sustaining model is theoretically derived. This model swiftly develops a balanced turbulent boundary layer, achieving a horizontally uniform flow field and effectively maintaining consistency between the inlet-given turbulent profile and physical reality. Additionally, by incorporating the velocity component of the downward-flow in front of the pier and the average shear stress around the pier into the excess shear stress model, the refined wall shear stress model accurately estimates the scouring contributions of the downward-flow and the horseshoe vortex system in this region. The numerical results including the maximum scour depth, location, and scour pit shape are consistent with experimental findings. The findings demonstrate that the numerical approach proposed in this study effectively addresses the issue of inadequate estimation of turbulent characteristics in scour pit at the leading edge of bridge piers using the RANS method. This method offers novel insights and approaches for addressing local scour issues in bridges and offshore wind turbines, as well as vortex-induced vibration issues in submarine pipelines.
During the floating transportation and installation of immersed tube tunnels, the mechanical stability of the mooring system is a key factor governing construction safety. Current conditions and mooring-line arrangements are two major factors controlling the magnitude and distribution of mooring-line tensions. However, their coupled effects and the applicability of different calculation methods remain insufficiently understood. Based on a large-cross-section immersed tube tunnel project, this study employed a semi-empirical method specified in the Chinese Code for Loads on Port Engineering and a three-dimensional floating-body-mooring numerical model established in ANSYS AQWA. Multiple combinations of current velocity and direction were considered to compare the mooring-line responses under five typical arrangements corresponding to different construction stages. The effects of current conditions and mooring configurations on the magnitude, distribution, and transfer of mooring-line loads were systematically examined. The results show that current velocity is the dominant factor controlling the magnitude of mooring-line tensions, which generally increase with the square of the current velocity. Changes in current direction directly alter the principal load-bearing mooring-line group, and a current velocity of 1.5 m/s during the falling tide represents the most unfavorable current condition throughout the construction process. The mooring-line arrangement governs the spatial distribution and concentration of the line loads. During the floating transportation and mooring stages with multi-line constraints, the maximum mooring-line tensions calculated using China’s code-based method are 18.5–25.2% higher than those obtained from the numerical simulations, indicating relatively conservative predictions. In contrast, during stages with weakened constraints, such as line release and positioning in the foundation trench, the numerical model captures more pronounced local load concentration, yielding maximum tensions 19.4–28.8% higher than those predicted by the code-based method. Across all operating conditions, the maximum mooring-line tensions calculated by the code-based method and numerical model are 924 and 750 kN, respectively. This study clarifies the coupled effects of current conditions and mooring-line arrangements on mooring-load transfer and identifies the applicable scenarios of the two calculation methods. The findings provide a quantitative basis for calculation-method selection, mooring-force assessment, and construction-safety management during immersed tube tunnel installation.